Help with Solaris 8


 
Thread Tools Search this Thread
Operating Systems Solaris Help with Solaris 8
# 8  
Old 01-23-2017
It could be a poor contact on an add-in card. I would power down, pull out each add-in card, and plug it back in again just to make sure the edge contacts are making. Perhaps this machine has been around a while and card(s) need reseating.
# 9  
Old 01-25-2017
Quote:
Originally Posted by DukeNuke2
Try to run devfsadm -Cv to get rid of device entries that are not used anymore.
I tried doing it but see see the same output of cfgadm -al as sent before and still no C1 controller in the list

Whenever i reboot the server glm issue pops up then none of the commands work but after couple of hours glm issue disappears and commands starts tot work

Thanks,
P
# 10  
Old 01-27-2017
Under normal circumstances no system will change its behaviour i.e., commands which don't work just start working after a couple of hours of running. There are only so many things that can cause it.

1. The system is running something at boot time which is time-based and toggling off something for a couple of hours.
2. A peripheral system is toggling something for a couple of hours e.g. a SAN is making volumes unavailable at certain times.
3. Or most likely it is a hardware problem e.g. as the system heats up things start working, see my post#8.
Login or Register to Ask a Question

Previous Thread | Next Thread

4 More Discussions You Might Find Interesting

1. Solaris

Patching Procedure in Solaris 10 with sun cluster having Solaris zone

Hi Gurus I am not able to find the patching procedure for solaris 10 ( sol10 u11) to latest patchset with sun cluster having failover zones so that same I should follow. Take an instance, there are sol1 and sol2 nodes and having two failover zones like sozone1-rg and sozone2-rg and currently... (1 Reply)
Discussion started by: nick101
1 Replies

2. Solaris

root disk mirroring in solaris volume manager for solaris 10

Need a procedure document to do "root disk mirroring in solaris volume manager for solaris 10". I hope some one will help me asap. I need to do it production environment. Let me know if you need any deatils on this. Thanks, Rama (1 Reply)
Discussion started by: ramareddi16
1 Replies

3. Solaris

Unable to login using ssh,telnet onto my solaris machine with solaris 10 installed

Hi, I am unable to login into my terminal hosting Solaris 10 and get the below error message "Server refused to allocate pty ld.so.1: sh: fatal: libc.so.1: open failed: No such file or directory " Is there anyways i can get into my machine and what kind of changes are required to be... (7 Replies)
Discussion started by: sankasu
7 Replies

4. Solaris

application compiled on solaris 10 throwing error when executed on solaris 9

I have compiled my application on Solaris 10 with following description SunOS ldg1 5.10 Generic_138888-03 sun4v sparc SUNW,Sun-Blade-T6320 The compiler is Sun C++ 5.9 SunOS_sparc Patch 124863-01 2007/07/25 But when installing the application on Solaris 9 SunOS odcarch02 5.9... (2 Replies)
Discussion started by: ash_bit2k2
2 Replies
Login or Register to Ask a Question