Hi,
I need to block ssh port 22 from all the servers except one server ip.
Until solaris11.3 and below, I used to do like below(under /etc/ipf/ipf.conf),and it's working fine
pass in quick from $server_ip to any port=22
block in quick from any to any port=22
But I tried almost same in... (1 Reply)
After some problems, I have installed Solaris 11.4. The warnings saidWARNING: /pci@0,0/.....
(xhci1): Connecting device on port 5 failed
WARNING: /pci@0,0/.....
(xhci1): Connecting device on port 6 failed
Preparing image for use
Unable to mount media
Requesting System Maintenance Mode
(See... (4 Replies)
Hi all,
Just istalled Solaris 11.
Want to configure network interfaces and got some problems:
#dladm show-phys
#
#dladm show-link
#
If i run ifconfig -a, i am getting 2 lo0 (loopback) interfaces and thats all.
I can't enable interface, can't list it, can't assign IP to it.
Can... (2 Replies)
I am trying to connect via Xmanager 4 to a T4-2 server running Solaris 11.
I checked the /etc/gdm.custom.conf file.
The error I get is
The MAC (Message Authentication Code) of packet is incorrect
When I start the Xmanager on soalris I get a message
/dev/fb (file or directory) does not... (2 Replies)
Short version:
pfexec zpool scrub rpool fails saying I do not have permission to perform that action. Apparently scrub is not one of the pfexec allowed actions. Any idea on how to get around it?
Long version:
I got tired of manually running scrubs and am trying to set it to happen... (4 Replies)
Hi,
I'm new on this forum. I'm working on Solaris 11 (Express Edition) and I must install some programm created only for RedHat system (I don't want to buy or download RedHat). So I search for this tools and I find a working script for Solaris 9 and 10, but I need that for Solaris 11. So I search... (1 Reply)
Hello,
I am trying to install Nmap on my Solaris machine. I got errors at the very last of "make" command though. Could someone point me out what I am lacking?
Thank you!
Nmap version: 5.50 (nmap-5.50.tar.bz2)
Solaris version (cat /etc/release):
Error message ( run "./configure &&... (0 Replies)