I have a quick question.
Is that even possible for the NIC to have a failed Status?
I mean the NIC card as WHOLE which has 4 Ethernet Ports and only 1 failing.
If it was a hardware problem then there are ways to look into it right?
More likely it looks like an application problem?
Well, I've only seen status "FAILED" on a NICs that were part of an IPMP group and there was some problem with communication (for example wrong VLAN configured on a switch side). I don't know how NIC's hardware failure would manifest, but in your case I'd say it is an application problem.
DEPRECATED means that outgoing IP traffic should not go to that interface.
I suggest to delete deprecated from /etc/hostname.ce0 and /etc/hostname.ce3.
Immediately applying it can result in an application failure (and even in a kernel panic):
But this is not related to the FAILED status. Perhaps it's caused by a bad cable or a bad LAN switch configuration?
Another recommendation: have the latest GigaSwift driver patch (118777-18) installed.
ce0 was at a failed status because the patch cable was bad.
Once we switched it, it was back up and running.
Those interface are having -deprecated because I want the virtual interface to take control of the in/out going traffic. Applications rely on that virtual IP. In any case the now that ce0 is back up. If ce3 fails, ce0's virtual interface should come up.
Hello Admins,
My ask is how can I add two different subnet IPs to same box with two different gateways?
The issue is I can connect to the box when I am on ethernet LAN, but I am not able to connect to the same IP when I am on wifi. The server is RHEL 7 VM on vmware.
How can I get connected... (4 Replies)
Dear All
I want tune my NIC's rps, rfs and xps value.
In my system I have two NIC (eth0, eth1) and I have a bond0 ( eth0, eth1).
Here is the question? Which device should I modify ?
eth0 and eth1? or just modify bond0 or modify all device (eth0, eth1, bond0)
Any advice is welcome.... (0 Replies)
I am new in squid proxy.
My question is how to (and if it's necessary) to set one NIC for inbound traffic (http requests) and one NIC for outbound traffic (http answers)?
Thank you in advance! (4 Replies)
I couldn't install my nic in solaris 10. I compiled and added
the driver but failed to attach the driver and ifconfig output
shows only loopback dev. Please see the following output and tell
me whether my nic has been detected and why the driver failed to
attach?
My nic is detected in linux... (0 Replies)
Hi
The Autosys job that call DOS batch file which in turn calls java and this java program has successful completion though there are series of exception occurred in the data it handles and want the job to be set to Fail in its autosys, how could it be done?
a.bat
{
java sample.class
... (1 Reply)
Hi can someone tell me what command i can use to find the NIC status im using the bash shell. I'v tried ifconfig -a but this comes back as command not found. (3 Replies)
Hi folks,
I wrote a ksh program which run scripts from remote server.
To check the status code I wrote the following function:
check_remote_status()
{
status_code=`tail -1 $installLog`
if ] ; then
echo $errMsg | tee -a $installLog
exit 1
else
echo $validMsg >> $installLog
fi... (9 Replies)
Hello,
hi guys I don't know what is the problem with my NIC I can ping the Localhost (LOOPBACK) but when I run a scripts to check the NIC statuse it's shown the NIC DOWN sooo what could be the problem and what is the best way to start trouplshooting the NIC in SUN-SOLARIS.
Regards,
Karim
... (3 Replies)