10 More Discussions You Might Find Interesting
1. IP Networking
Hi please help,
theoretically I',m interested in starting a streaming service using multicast IP service. I'd like to know how do I get an IP address that I can send my data too? (please don't just point me too Internet Assigned Numbers Authority as ive been there and it just seem to state... (1 Reply)
Discussion started by: fishman2001
1 Replies
2. IP Networking
Hello all,
I am trying to receive (tcp/udp/sctp) traffic from all IPs and, eventually, all ports of an IPv6 address block using as few sockets as possible short of implementing my own network stack.
One possible solution was to associate an IP block to an interface then bind to that... (6 Replies)
Discussion started by: redwil
6 Replies
3. Solaris
hi,
how to assign static ip address to the server having solaris 10. assign static ip to nge0 which will sustain across reboots which will include all settings including gateway setting etc.. (2 Replies)
Discussion started by: pankajd
2 Replies
4. IP Networking
Hi ,
by default the physical interface (eth1) and virtual interface eth1:0 will be having same mac address, is there any way we can assign separate mac addresses for both the interfaces.
would some one help me out in this.
Thanks
Gopi (1 Reply)
Discussion started by: Gopi Krishna P
1 Replies
5. Solaris
On Solaris OS, We use the following command to config the multicast address for NIC in order to process the multicast packets:
# route add 228.228.228.228 10.101.10.2
Where " 228.228.228.228 " is the multicast for specified NIC ip 10.101.10.2 .
Also use the netstat -nr, the above set could... (0 Replies)
Discussion started by: Frank2004
0 Replies
6. Solaris
I m having interface ce0 ce1 and its sub interfaces for that.
I want to give MAC addresses for the same.
How will I assign it.
Please give solution for the same (4 Replies)
Discussion started by: sunray
4 Replies
7. Solaris
On SUN Solaris 10, if I want to multicast packets between nodes, whether it must config the multicast IP from OS, if yes, how to do it? (0 Replies)
Discussion started by: Frank2004
0 Replies
8. Linux
On Linux, I have configured two different IP address for two network device eth0 ,eth1 , in my program, I want to multicast differently on these two network, I know it must add route for single network and I try to config another route for second network,but it can not work correctly, how to config... (0 Replies)
Discussion started by: Frank2004
0 Replies
9. UNIX for Dummies Questions & Answers
Hello,I am new to unix,i want to know how to assign virtual ip address to a system that is in my personal network? (1 Reply)
Discussion started by: veeru_jarugula
1 Replies
10. HP-UX
Hi, there
On HP-UX, I want to multicast packets on two different IP network repectively.
The two NIC are configured with two different IP. The routes are added with one default and one net for each IP . The multisender programs bind their own local IP, multireceiver programs add the... (0 Replies)
Discussion started by: Frank2004
0 Replies