Sun T1000 performance

6 More Discussions You Might Find Interesting

1. Solaris

T1000 Sun Solaris server root login blocked

Hi, Can someone tell me how to re-activate the root login of T1000 sun solaris server. Thx

2. Solaris

sun v240 performance

Hi, we are having one sun v240 server, now this server is performing very slow, checked using top, iostat and vmstat commands, output is looking normal, but the performance is very slow and generating more traffic in network, how can we resolve this. Regards RJS

3. Filesystems, Disks and Memory

Poor read performance on sun storedge a1000

Hello, i have a a1000 connected to an e6500. There's a raid 10 (12 disks) on the a1000. If i do a dd if=/dev/zero of=/mnt/1 bs=1024k count=1000 and then look at iostat it tells me there's a kw/s of 25000. But if i do a dd of=/dev/zero if=/mnt/1 bs=1024k count=1000 then i see only a...

4. Solaris

Sun T1000 application low performance

Hello All. I have Sun T1000 server with Solaris 10. On T1000 installed EMC smarts, application for monitoring network devices via SNMP + SNMP. So, Smarts has own DB (contains object - devices and relationships), file takes 30 mb, now, all queries to DB works very slow, so Smarts works too slow,...

5. Solaris

Enhance Sun Solaris 10 performance ?

Guys where can i find values to add in /etc/system to make sun solaris 10 working better ? im sure there is alot of values but i dont know from where i can find them if you know any please send direct and if you know another sites send links to it, thanks so much.

6. AIX

Network performance problem between AIX and SUN ethernet gigabit

I am posting this as an FYI. I burned a lot of time on digging for this solution. The problem was performance between newer AIX p series boxes and a sun 4500 with a fiber nic. I tried many misc. solutions but this turned out to fix the issue. My bandwidth benchmark went from around 20MB/sec to...

LEARN ABOUT DEBIAN

mpt

MPT(4)							   BSD Kernel Interfaces Manual 						    MPT(4)

NAME

     mpt -- LSI Fusion-MPT SCSI/Fibre Channel driver

SYNOPSIS

     To compile this driver into the kernel, place the following lines in your kernel configuration file:

	   device scbus
	   device mpt

     Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

	   mpt_load="YES"

DESCRIPTION

     The mpt driver provides support for the LSI Logic Fusion-MPT family of SCSI, Fibre Channel and SAS controllers.

HARDWARE

     The following controllers are supported by the mpt driver:

     o	 LSI Logic 53c1030, LSI Logic LSI2x320-X (Single and Dual Ultra320 SCSI)
     o	 LSI Logic AS1064, LSI Logic AS1068 (SAS/SATA)
     o	 LSI Logic FC909 (1Gb/s Fibre Channel)
     o	 LSI Logic FC909A (Dual 1Gb/s Fibre Channel)
     o	 LSI Logic FC919, LSI Logic 7102XP-LC (Single 2Gb/s Fibre Channel)
     o	 LSI Logic FC929, LSI Logic FC929X, LSI Logic 7202XP-LC (Dual 2Gb/s Fibre Channel)
     o	 LSI Logic FC949X (Dual 4Gb/s Fibre Channel)
     o	 LSI Logic FC949E, LSI Logic FC949ES (Dual 4Gb/s Fibre Channel PCI-Express)

     The Ultra 320 SCSI controller chips supported by the mpt driver can be found onboard on many systems including:

     o	 Dell PowerEdge 1750 thru 2850
     o	 IBM eServer xSeries 335

     These systems also contain Integrated Raid Mirroring and Integrated Raid Mirroring Enhanced which this driver also supports.

     The SAS controller chips are also present on many new AMD/Opteron based systems, like the Sun 4100.  Note that this controller can drive both
     SAS and SATA drives or a mix of them at the same time. The Integrated Raid Mirroring available for these controllers is poorly supported at
     best.

     The Fibre Channel controller chipset are supported by a broad variety of speeds and systems.  The Apple Fibre Channel HBA is in fact the
     FC949ES card.

     This driver also supports target mode for Fibre Channel cards.  This support may be enabled by setting the desired role of the core via the
     LSI Logic firmware utility that establishes what roles the card can take on - no separate compilation is required.

SEE ALSO

     cd(4), ch(4), da(4), pci(4), sa(4), scsi(4), targ(4), mptutil(8), gmultipath(8)

     LSI Logic Website, http://www.lsilogic.com/.

HISTORY

     The mpt driver first appeared in FreeBSD 4.6.

AUTHORS

     The mpt driver was originally written for FreeBSD by Greg Ansley and marginally improved upon by Matt Jacob <mjacob@FreeBSD.org>.

     Justin Gibbs <gibbs@FreeBSD.org> and Scott Long <scottl@FreeBSD.org> have made more substantial improvements.

BUGS

BSD
								   May 13, 2010 							       BSD

Solaris