9 More Discussions You Might Find Interesting
1. Shell Programming and Scripting
Good Morning,
I'm trying to automate the resync process after a mirror replacement on Solaris. To avoid resyncing all the drives at once, I'm trying to use metastat for each drive to determine if the drive is still resyncing or if it is done (Okay). The following test lines seem to always show... (4 Replies)
Discussion started by: Stellaman1977
4 Replies
2. AIX
Hi Admins,
I am having a whole system lpar in open firmware state on HMC.
How can I bring it to running state ?
Let me know. Thanks. (2 Replies)
Discussion started by: snchaudhari2
2 Replies
3. UNIX for Dummies Questions & Answers
In my infinite lack of wisdom, I brought a Solaris 10(Sparc, 64 bit ) system down to init 1, detached a metadrive so that I could run format->analyze->refresh on it, and then reinit'd and reattached it .
It started syncing the drive as it's a submirror of a mirrored drive, which happens... (8 Replies)
Discussion started by: the.gooch
8 Replies
4. Solaris
Hi, Here is the issue: There are 4 disks on this Sun x4150 system under Solaris 10, but only 1 disk can be seen by the OS. I've tried commands disks and devfsadm but not working. It's an important production server, so 'reboot -r' is not a choice.
# format < /dev/null
Searching for... (6 Replies)
Discussion started by: aixlover
6 Replies
5. AIX
Hi All,
I have two mount points have the same data with little changes between them
/appabc1
/appabc2
Both of them have the same data, there is some little changes on the data between them
I want /appabc2 to has the same data of /appabc1 exactly including to those little changes... (6 Replies)
Discussion started by: Mr.AIX
6 Replies
6. Shell Programming and Scripting
Hi All,
i am aware that there is a difference between:
1. rsync -n -av /tmp .
2. rsync -n -av /tmp/ .
I would like to do the first option. But if i use a variable (rsync -av $log .), the command behaves like a second option (with the trailing slash)
Is there any way to use a... (2 Replies)
Discussion started by: c00kie88
2 Replies
7. Linux
Can anyone could tell me what is the meaning of this problem:
Last successful check resync is greater than min sync interval (1195785433 > 7200)
And what can do to solve this problem.
Thank you..Please HElp me! (4 Replies)
Discussion started by: o_m_g
4 Replies
8. UNIX for Dummies Questions & Answers
I am using raidctl on a v440 disk and noticed it resyncs after every boot, which takes about 30 minutes because of the size of the partition. I am concerned with what happens during the resync if "writes" happen to the disk before it is complete?
Any info would be helpful.
Thanks (0 Replies)
Discussion started by: csgonan
0 Replies
9. UNIX for Dummies Questions & Answers
Hello,
I would like to know if there are commands that can be used to monitor the state of physical disks (including RAID) under AIX and SUN unix platforms?
Thank you in advance. (4 Replies)
Discussion started by: VeroL
4 Replies