Solaris

Can't tell you that, as I'm not sure (I'm suspecting it is the case, though). Anyway, let us know how it went.

Aixlover , your comment is correct, the luxadm only shows CONNECTED when you configure zones in the switches.

The status CONNECTED o NOT CONNECTED not indicate a physcical connection, luxadm CONNECTED indicate a communication betwen FC Initiator (HBA) and FC Target (Storage port normally), if zone not exists this communication not exists and the status is NOT_CONNECTED

Thank you both. I'll create zones on the switch next week and keep you posted.

Please post the output of :
1.

Code:

cfgadm -aol show_FCP_dev

2.

Code:

scan

or

Code:

sgscan

The result of your first command is OK, but yeah, luxadm -e port should show CONNECTED. Have you added the WWNs of the HBA card to the SAN switch DB?

Sorry about the delayed reply. Here is the result: After zones are created on switches for the new connections, everything is fine with the outputs of cfgadm and luxadm commands.