Zone failes to boot due to mount issue, dir exists in zone.
I have two physical servers, with zones that mount local storage.
We were using "raw device" in the zonecfg to point to a metadevice on the global zone (it was not mounted in the global zone at any point).
It failed to mount on every boot because the directory existed in the zone.
I changed it to a lofs mount, so at that point it is mounted in the global zone and being shared.
I still get the same error, I have to delete the directory in the zone prior to booting the zone in order to mount, or for the zone to even boot. It fails cause the directory exists, and the zone will not boot when the physical server reboots...
Has anyone een this before? I'm stumped, I dont want to have to make a script that deletes the directory.
Config seems be little bit strange. If you used
why are presented inherited directories???
Anyway if you are approaching metadevice from inside of local zone it should be accessed as raw device (but this is not rule). If you are using lofs see config example below.
Can I ask about hashes in output?? They are replacing something what shouldn't be visible on public??
OK, try this then:
1. Set autoboot to false
2. Boot up the zone (or leave it running if it is already up)
3. Reboot global zone
4. After the global zone is up again, run:
Hi, hoping someone can help, its been a while since I used Solaris.
After creating a NGZ (non global zone), the NGZ can access the GZ (Global Zone) and the GZ can access the NGZ (using ssh, zlogin)
However, the NGZ cannot access any other netwqork devices, it can't even see the default router
... (2 Replies)
Dear all,
recently, I migrated a solaris zone from one host to another. The zone was inside of a zpool. The zpool cotains two volumes.
I did the following:
host1:
$ zlogin zone1 shutdown -y -g0 -i0 #Zone status changes from running to installed
$ zpool export zone1
host2:
$ zpool... (2 Replies)
So this is Solaris 11.1. I have a Global zone that has several non-global zones running in it. I want to change the capped-memory.physical resources setting in ALL the zone configs of the running zones.
if I were to do this manually here's what I would do:
zonecfg -z zone1
select... (2 Replies)
can some one help me out as it is showing 2 different time zones in global zone and nonglobal zone .In global zone it is showing in GMT while in nonglobal zone i it showing as PDT.
System in running with solaris 10 (3 Replies)
Hi Greetings...
I have an issue in connecting the zone from outside the network and it is because of default gateway. I can ping default gateway from inside the zone and not able to ping from global zone due to different VLAN issue. If i add two different gateways and restart network services,... (2 Replies)
Hi All
There is one folder in global zone I just want to share the same folder innon global zone. How can i do it?
pls send me script for this. (2 Replies)
Hi All ,
I try to install some packages in my global zone...
On the execution of the installion of the script it quits by saying the error
"Non global zone check failed"
Kindly help me in this regard
Thanks in advance,
jeganr (7 Replies)
Hi,
I have a primary/slave Bind 9 setup running on a Solaris 10 platform. Everything is hunky dorey, except for when I make a zone file change and up the serial the file that is transferred to the slave looses all its comments, and the entries are place in alphabetical order.
I administer many... (1 Reply)