Hi,
I am doing aws security group auditing every day to find the difference. I am using git to find the difference. But some times some security group rules order is changing up and down(swapping lines). So 'git diff' command gives this as a difference which i dont want(i need only new lines... (2 Replies)
Hi Guys,
I m not ble to perform metattaach with new disk.
Getting below Error:-
-bash-3.00$ sudo /usr/sbin/metattach d0 d10
metattach: server03: /dev/md/rdsk/d10: No such device or address
This is wht my metastat -p shows:-
-bash-3.00$ sudo /usr/sbin/metastat -p
Password:
d4 -m... (4 Replies)
I recently had a vendor hot-swap a faulty hard drive on my system. The fault was determined before there were any noticeable errors with regular operation on the user end. The vendor claims to have replaced the faulty hard drive. Is there a way to verify that the hard drive has been replaced? I... (3 Replies)
At a new job, I've inherited a handful of Solaris 10 SunFire V240 servers.
I noticed that the metadevices are not consistent, in a way that I've not seen before....
internal mirrored disks:
metadevice d60 has c1t0d0s6 as submirror 0 (d61) and c1t1d0s6 as submirror 1 (d62)
metadevice... (1 Reply)
Hi All,
I need to sum numbers, in bash, input is this:
10.00
12.33
14.99
134.00
1211.09
130.01- <--- it is negative, but "-" is at the end..
901.99
10.34- <--- another negative number...
bc -l is giving me error so only solution to my problem would be to swap - to the... (3 Replies)
I'm mirroring up a T2000. Able to metainit and metattach all partitions with the exception of root. Getting the following error:
metattach: <hostname>; c1t1d0s0; is mounted on /
I'm stumped. By the way, target 1 is the boot disk. (7 Replies)
My unix box always experience high memory pages swapped out. This box has 8GB physical memory and the utilisation is only around 40%. What should be done to lower the memory pages swapped out problem ?
Thanks.:) (3 Replies)
Dear all,
I found a big problem with my solaris9 server when user said their application run too slow then I try to check cpu, memory but both of them are normally. One thing that I see form value of vmstat like this
kthr memory page disk faults ... (2 Replies)
Is there a way to do this in Solaris?
For instance, suppose I run the following:
$ swap -l
swapfile dev swaplo blocks free
/dev/md/dsk/d501 85,501 16 16780208 16780208
$ swap -s
total: 3377368k bytes allocated + 519416k reserved = 3896784k used, 11011992k available... (1 Reply)