9 More Discussions You Might Find Interesting
1. Solaris
Hi All
I would need to do hard code of nxge0 nic to full duplex & 1000mbps. So that whenever solaris server come up after reboot. it will show full duplex & 1000mbps setting only.
Please also let me know how to do it online through command.
regards (0 Replies)
Discussion started by: amity
0 Replies
2. UNIX for Dummies Questions & Answers
I have a RHEL 5 system with a bonded interface configure using only one network port (eth0). So I have config file for ifcfg-bond0 and ifcfg-eth. I'd like to configure eth5 to be the second SLAVE in the bond. My question is, after I modify ifcfg-eth5, can I add eth5 to the bond0 interface without... (1 Reply)
Discussion started by: westmoreland
1 Replies
3. Programming
I have been trying to split up my src directory to clear out files that are not re-compiled very often. Now I have the following setup in my trunk,
trunk/bld
trunk/src/
trunk/src/src_server
trunk/makefile.linux
In the make file, I have compile rules
SOURCELOC = src
# compile src c++... (4 Replies)
Discussion started by: LMHmedchem
4 Replies
4. IP Networking
This is my situation
DOS pc serial cable (sl0) Linux Pc eth1
192.168.0.10 <-------------------->192.168.0.2 <------------>192.168.0.1 (router)
I connected the linux pc and the dos pc with a SLIP (serial line internet protocol), so they can communicate in the sl0 interface.
... (3 Replies)
Discussion started by: mghis
3 Replies
5. SCO
Hi all
I have installed a demo version of SCO OpenServer 5.0.2, I finally found it is Desktop Interface, I would like to know how to change its interface to dos based interface?
If you have any ideas, please tell me then. Thank you (2 Replies)
Discussion started by: TinhNhi
2 Replies
6. Solaris
Dear all,
I am a newbie in solaris and I need your advice.
I have a Solaris version 5.9 installed on Sunfire V240.
I am able to ssh the machine from putty remotely.
My problem is that I cannot see the display from KVM switch I have connected to it. I need also to be able to see the GUI... (2 Replies)
Discussion started by: mbouster
2 Replies
7. UNIX for Dummies Questions & Answers
Hi,
While installation of apache on linux, we perform the below tasks.
1) Untar
2) configure
3) make
4) make install.
I wanted to understand the difference and working of configure/make/make install.
Can any one help me understanding this?
Thanks in advance. (1 Reply)
Discussion started by: praveen_b744
1 Replies
8. Solaris
I attached a README file that I will refer to.
I successfully completed everything in the README file until step 4.
# pwd
/gani/gani-2.4.4
# ls
COPYING Makefile.macros gem.c
Makefile Makefile.sparc_gcc gem.h
Makefile.amd64_gcc ... (1 Reply)
Discussion started by: Bradj47
1 Replies
9. Linux
Hi,
Recently I install a package and try to do a make and make install.
However, in the make it gives me below error:-
make:Nothing to be done for 'install-exec-am'
make:Nothing to be done for 'install-data-am'
Can anyone please explain to me what does this mean? I have been trying... (1 Reply)
Discussion started by: ahjiefreak
1 Replies