I have a jumpstart client that is not requesting the tftp boot file. The rarp function is working, hostname and ip are set ok, but it hangs after that.
tcpdump output:
syslog output:
This jumpstart server has worked on 150+ clients in the last 6 months...just seems to be this one client (v445).
I have reset OBP values to defaults, power cycled the client a few times, and did a reboot of the jumpstart server.
What are the next options? TIA
Last edited by DukeNuke2; 12-18-2010 at 02:19 PM..
I've followed a few guides and have what appears to be a working jumpstart server. I can PXE boot a bare system, it gets an IP and launches the installer. However, it takes me to the screen:
SunOS Release 5.10 Version generic-147148-26 64 bit
Copyright (c) 1983, 2013, Oracle and/or its... (1 Reply)
I 'm tryin to install a solaris server After all the system initialization & extraction of flash archive installation aborts with following error ..
Does anyone know what could be the issue for the same ?
Any help would be appreciated
Extracted 2205.05 MB ( 99% of 2205.54 MB... (6 Replies)
Hi ,
I am facing this issue while restoring flash archive from jumpstart server.The image was aroung 9 gb (5.9 release) and we have restored the other images successfully bigger than this size to other machines we have never faced this issue .Please advice me on this issue .
Extracted 100 %... (0 Replies)
I am performing this installation on a Sun T5220. There is an aftermarket Adaptec StorageTek raid controller card installed. I have created the raid array, and it is referred to as c1t0d0. Here is the profile I have created:
install_type
initial_install
system_type server
cluster SUNWCXall... (4 Replies)
I have created profile file for zfs root (flash) on a wanboot server when i try to validate the rules file with check i get following error .. i 'm not sure why i 'm getting this error .. can any one help me on this ?
# ./check
Validating rules...
Validating profile profile...
Error in... (0 Replies)
Can I use a Jumpstart enviroment on x86 to install a sparc64 client?
The idea is to install Solaris in an virtual environment (Sun Virtual Box) running on a pc (AMD), configure a Jumpstart server, and have a SUN Ultra 60 (sparc64) installed via the Jumpstart server.
The SUN has no cdrom... (4 Replies)
I am trying to find an approach that has been effective for automating the installation of Solaris 10 x86 using Jumpstart technology. I have configured an Jumpstart server and a Solaris dhcp server with appropriate macros for passing the client information about its boot environment. The problem is... (7 Replies)
I'm new to the forum and I know just enough about this topic to make me dangerous. This question is probably pretty basic to most of you, but here goes:
I've got two servers that I'm connecting to via TCP/IP. The issue is that I'm losing connectivity between the two after a certain period of... (5 Replies)
Hi
I just configured a jumpstart server for x86 and sparc clients. I don't use a dhcp server, so I configured /etc/ethers and did add_install_client to update /etc/bootparams. The sparc installation ist working, but the x86 installation stops after CD1 was successfully installed.
What I did:
I... (2 Replies)