For the life of me, I cannot figure out the syntax unless it's my configuration. Zone path is /zpool/zones/oracle11zone2 It is not running.
Code:
-bash-3.00# zfs snapshot zpool/zones/oracle11zone2@prepatch
cannot open 'zpool/zones/oracle11zone2': dataset does not exist
-bash-3.00# zfs snapshot /zpool/zones/oracle11zone2@prepatch
cannot snapshot '/zpool/zones/oracle11zone2@prepatch': leading slash in name
Code:
-bash-3.00# zpool status
pool: rpool
state: ONLINE
scrub: none requested
config:
NAME STATE READ WRITE CKSUM
rpool ONLINE 0 0 0
c1t1d0s0 ONLINE 0 0 0
errors: No known data errors
pool: zpool
state: ONLINE
scrub: none requested
config:
NAME STATE READ WRITE CKSUM
zpool ONLINE 0 0 0
raidz2 ONLINE 0 0 0
c1t0d0 ONLINE 0 0 0
c1t2d0 ONLINE 0 0 0
c1t3d0 ONLINE 0 0 0
errors: No known data errors
-bash-3.00#
-bash-3.00# zfs snapshot zpool/zones/oracle11zone2@prepatch
cannot open 'zpool/zones/oracle11zone2': dataset does not exist
-bash-3.00# pwd
/
-bash-3.00# ls /zpool/zones/
oracle11zone2
oracle11zone2clone1
-bash-3.00#
you can not take a snapshot from a zone. only from a zfs filesystem or zpool. "oracle11zone2" is just a directory inside your filesystem and not a zfs filesystem!
Hi, hoping someone can help, its been a while since I used Solaris.
After creating a NGZ (non global zone), the NGZ can access the GZ (Global Zone) and the GZ can access the NGZ (using ssh, zlogin)
However, the NGZ cannot access any other netwqork devices, it can't even see the default router
... (2 Replies)
Dear all,
recently, I migrated a solaris zone from one host to another. The zone was inside of a zpool. The zpool cotains two volumes.
I did the following:
host1:
$ zlogin zone1 shutdown -y -g0 -i0 #Zone status changes from running to installed
$ zpool export zone1
host2:
$ zpool... (2 Replies)
can some one help me out as it is showing 2 different time zones in global zone and nonglobal zone .In global zone it is showing in GMT while in nonglobal zone i it showing as PDT.
System in running with solaris 10 (3 Replies)
I have two physical servers, with zones that mount local storage.
We were using "raw device" in the zonecfg to point to a metadevice on the global zone (it was not mounted in the global zone at any point).
It failed to mount on every boot because the directory existed in the zone.
I... (6 Replies)
Hi Greetings...
I have an issue in connecting the zone from outside the network and it is because of default gateway. I can ping default gateway from inside the zone and not able to ping from global zone due to different VLAN issue. If i add two different gateways and restart network services,... (2 Replies)
Hi,
I have a primary/slave Bind 9 setup running on a Solaris 10 platform. Everything is hunky dorey, except for when I make a zone file change and up the serial the file that is transferred to the slave looses all its comments, and the entries are place in alphabetical order.
I administer many... (1 Reply)