I've got Sun Fire T2000 with two LDoms - primary and ldom1, both being Solaris 10 u8. Both can be accessed over the network (ssh, ping), both can access the network, but they can't ping or ssh to each other.
I only use e1000g0 interface on T2000, the primary ldom has an address on it, ldm has a virtual switch configured on that interface and ldom1 has a vnet0 attached to this virtual switch.
Played with it for a while, installed second LDom and found that the two LDoms can see each other but none can talk to the control (primary) domain. It must have something to do with the virtual switch I guess.
Here are the interfaces:
Code:
root@krikkit ~ # ifconfig -a
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 index 1
inet 127.0.0.1 netmask ff000000
e1000g0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 2
inet 192.168.140.210 netmask ffffff00 broadcast 192.168.140.255
ether 0:3:ba:d8:e0:94
And here are all the interfaces found by the primary domain:
Code:
root@krikit ~ # dladm show-dev
vsw0 link: up speed: 100 Mbps duplex: full
vsw1 link: up speed: 100 Mbps duplex: full
e1000g0 link: up speed: 100 Mbps duplex: full
e1000g1 link: up speed: 100 Mbps duplex: full
e1000g2 link: unknown speed: 0 Mbps duplex: half
e1000g3 link: unknown speed: 0 Mbps duplex: half
I tried to "plumb" and "up" the vsw0 device, even give it a new address but that made no difference.
What interfaces do you guys use in the control (primary) domain? The physical e1000g0 (or what's there on your systems) or some virtual ldm interfaces? How do you configure them?
System: SPARC S7-2 Server; 2x8-core CPUs; 128Gb RAM; 2x600Gb HDD.
I have been experimenting on the above system, using ldmp2v to create "clones" of my physical systems as LDoms on the server when there was an unscheduled power outage. After the system came back up I had lost my LDoms, although... (7 Replies)
If I do ldm ls l ldom1 the memory block is as follows:-
MEMORY
RA PA SIZE
0x20000000 0x20000000 64G
0x1420000000 0x1020000000 16G
0x1c20000000 0x1420000000 16G
0x2420000000 0x1820000000 16G
0x2c20000000... (1 Reply)
help with bash script!
im am working on this script to make sure my server will stay online, so i made this script..
HOSTS="192.168.138.155"
COUNT=4
pingtest(){
for myhost in "$@"
do
ping -c "$COUNT" "$myhost" &&return 1
done
return 0
}
if pingtest $HOSTS
#100% failed... (4 Replies)
Hi all,
New to this forum.
I have just been reading through a historical thread about some issues with IPMP.
Some tips from "Peasant" where very useful. Please see below
"Just couple of more hints regarding VM.
For VDS, use one VDS - one guest LDOM, don't put everything in primary-vds.... (9 Replies)
I have a T4-1 with Solaris 11.1, LDom ver 3.0.0.1 and I'm encountering two problems with zones.
I'd greatly appreciate help on these, especially the first one.
I have created multiple guest LDoms, all Solaris 11.1, and they all work fine.
The first problem is that I can not boot any... (9 Replies)
Hi
I am using perl to ping a list of nodes - with script below :
$p = Net::Ping->new("icmp");
if ($p->ping($host,1)){
print "$host is alive.\n";
}
else {
print "$host is unreacheable.\n";
}
$p->close();... (4 Replies)
Hi,
I develop simple animation ping script on Solaris Platform. It is like Cisco ping.
Examples and source code are below.
bash-3.00$ gokcell 152.155.180.8 30
Sending 30 Ping Packets to 152.155.180.8
!!!!!!!!!!!!!.!!!!!!!!!!!!!!!.
% 93.33 success... % 6.66 packet loss...... (1 Reply)
We're just about to migrate a large application from an Enterprise 6900 to a pair of T5220s utilising LDOMs. Does anyone have any experience of LDOMs on this kit and can provide any recommendations or pitfalls to avoid?
I've heard that use of LDOMs can have an impact on I/O speeds as it's all... (9 Replies)
I have a Netra T5220 Solaris 10 server with LDoms installed and enabled. RAID1 is enabled in the control domain with the following slices:
d50 -m d51 d52 1
d51 1 1 c1t0d0s5
d52 1 1 c1t1d0s5
d10 -m d11 d12 1
d11 1 1 c1t0d0s0
d12 1 1 c1t1d0s0
d20 -m d21 d22 1
d21 1 1 c1t0d0s1
d22 1 1... (14 Replies)
