10 More Discussions You Might Find Interesting
1. Hardware
Can you mix DIMMs in a T6320 (sparc) blade? I have read/heard that the DIMMs in a memory bay must be identical but can you have different size DIMMs installed in the blade?
For instance, can you have 1 4GB DIMM in bay 0, 2 2GB DIMMs in bay 1, 4 1 GB DIMMs in bay 2 and 2 2GB DIMMs in bay 3 for a... (0 Replies)
Discussion started by: bluescreen
0 Replies
2. Solaris
Hi, I can't seem to get Graphs using Report Manager for Memory and Hard Disk. Only CPU is working fine. Following are some screen shots:
- Sun Management Center 4.0
http://img689.imageshack.us/img689/7555/smcu.jpg
- Performance Report
http://img25.imageshack.us/img25/3015/reportdo.jpg
By... (2 Replies)
Discussion started by: Mack1982
2 Replies
3. Solaris
Hi folks, can you please help to print cpu and memory configuration on sun host. (4 Replies)
Discussion started by: ggolub
4 Replies
4. Solaris
Hi,
I recently acquired an old Sun Fire v120 from work. I plan to play around with this at home whilst I'm studying for my SCSA exams. Only problem is it currently has no memory installed. I believe the memory modules required are 168 pin PC133 DIMMs. Unfortunately, the original Sun modules are... (3 Replies)
Discussion started by: skinyana
3 Replies
5. Solaris
Hi, this is my 1st post here, I don't know is it proper or not for the question I have, but I may try ask anyway, since it is question about sun's hw/sw issue...
I have my blade 1000 installed additional memory kits, it was originally 2G memory installed on Group0(Bank 0/2) Dimm slots, I got... (5 Replies)
Discussion started by: netshu
5 Replies
6. Solaris
Hi, I've been a member for a while but have never posted. I have a Sun Blade 100 desktop and I just installed Solaris 10 and it is unbearably slow. I only have 128 Meg of RAM and need to upgrade. I have searched and found many online resources that have RAM, but I was wondering if anyone has... (12 Replies)
Discussion started by: BrewDudeBob
12 Replies
7. Solaris
Hi
I am facing a problem with memory in SunOS 5.9. I just want to check the memory usage. Can anybody suggest me a command that will help me in this regard. (4 Replies)
Discussion started by: rajarsi.ghosh
4 Replies
8. Programming
Hi, I try to marshal a unsigned int and a char * into a buffer, and then unmarshal them later to get them out. I need to put the char * in the front and unsigned int at the end of the buffer. However, my system always give me "BUS ERROR". I am using Sun Sparcs Sloris 2.10.
My code to marshal... (6 Replies)
Discussion started by: nj302
6 Replies
9. Solaris
Hi, I try to marshal a unsigned int and a char * into a buffer, and then unmarshal them later to get them out. I need to put the char * in the front and unsigned int at the end of the buffer. However, my system always give me "BUS ERROR". I am using Sun Sparcs Sloris 2.10.
My code to marshal the... (1 Reply)
Discussion started by: nj302
1 Replies
10. UNIX for Dummies Questions & Answers
I would like to upgrade the memory in my Sun Blade 150 workstation. In reading through Sun's Blade 150 DIMM Installation Guide, it indicates that the memory must be "certified by Sun for the Sun Blade 150 system."
Does anyone know if any SDRAM, PC133 • CL=2 • Unbuffered • ECC • 133MHz • 3.3V ... (2 Replies)
Discussion started by: here2learn
2 Replies
ENUM
IEEE80211_STA_I(9) Internals ENUM IEEE80211_STA_I(9)
NAME
enum_ieee80211_sta_info_flags - Stations flags
SYNOPSIS
enum ieee80211_sta_info_flags {
WLAN_STA_AUTH,
WLAN_STA_ASSOC,
WLAN_STA_PS_STA,
WLAN_STA_AUTHORIZED,
WLAN_STA_SHORT_PREAMBLE,
WLAN_STA_WME,
WLAN_STA_WDS,
WLAN_STA_CLEAR_PS_FILT,
WLAN_STA_MFP,
WLAN_STA_BLOCK_BA,
WLAN_STA_PS_DRIVER,
WLAN_STA_PSPOLL,
WLAN_STA_TDLS_PEER,
WLAN_STA_TDLS_PEER_AUTH,
WLAN_STA_UAPSD,
WLAN_STA_SP,
WLAN_STA_4ADDR_EVENT,
WLAN_STA_INSERTED,
WLAN_STA_RATE_CONTROL,
WLAN_STA_TOFFSET_KNOWN,
WLAN_STA_MPSP_OWNER,
WLAN_STA_MPSP_RECIPIENT
};
CONSTANTS
WLAN_STA_AUTH
Station is authenticated.
WLAN_STA_ASSOC
Station is associated.
WLAN_STA_PS_STA
Station is in power-save mode
WLAN_STA_AUTHORIZED
Station is authorized to send/receive traffic. This bit is always checked so needs to be enabled for all stations when virtual port
control is not in use.
WLAN_STA_SHORT_PREAMBLE
Station is capable of receiving short-preamble frames.
WLAN_STA_WME
Station is a QoS-STA.
WLAN_STA_WDS
Station is one of our WDS peers.
WLAN_STA_CLEAR_PS_FILT
Clear PS filter in hardware (using the IEEE80211_TX_CTL_CLEAR_PS_FILT control flag) when the next frame to this station is transmitted.
WLAN_STA_MFP
Management frame protection is used with this STA.
WLAN_STA_BLOCK_BA
Used to deny ADDBA requests (both TX and RX) during suspend/resume and station removal.
WLAN_STA_PS_DRIVER
driver requires keeping this station in power-save mode logically to flush frames that might still be in the queues
WLAN_STA_PSPOLL
Station sent PS-poll while driver was keeping station in power-save mode, reply when the driver unblocks.
WLAN_STA_TDLS_PEER
Station is a TDLS peer.
WLAN_STA_TDLS_PEER_AUTH
This TDLS peer is authorized to send direct packets. This means the link is enabled.
WLAN_STA_UAPSD
Station requested unscheduled SP while driver was keeping station in power-save mode, reply when the driver unblocks the station.
WLAN_STA_SP
Station is in a service period, so don't try to reply to other uAPSD trigger frames or PS-Poll.
WLAN_STA_4ADDR_EVENT
4-addr event was already sent for this frame.
WLAN_STA_INSERTED
This station is inserted into the hash table.
WLAN_STA_RATE_CONTROL
rate control was initialized for this station.
WLAN_STA_TOFFSET_KNOWN
toffset calculated for this station is valid.
WLAN_STA_MPSP_OWNER
local STA is owner of a mesh Peer Service Period.
WLAN_STA_MPSP_RECIPIENT
local STA is recipient of a MPSP.
DESCRIPTION
These flags are used with struct sta_info's flags member, but only indirectly with set_sta_flag and friends.
AUTHOR
Johannes Berg <johannes@sipsolutions.net>
Author.
COPYRIGHT
Kernel Hackers Manual 3.10 June 2014 ENUM IEEE80211_STA_I(9)