You cannot set IP when IP type is set to exclusive.
You need to set ip type to shared from the zonecfg 1st layer, then you can set IP address when you do add net> and so on..
Don't try to set the IP address here. You only need to add the physical interface to the zone configuration when using exclusive IP interface. As already told, the IP settings are in that case done by the non global zone, not by the global one (either through ifconfig or zonecfg).
Dear all,
recently, I migrated a solaris zone from one host to another. The zone was inside of a zpool. The zpool cotains two volumes.
I did the following:
host1:
$ zlogin zone1 shutdown -y -g0 -i0 #Zone status changes from running to installed
$ zpool export zone1
host2:
$ zpool... (2 Replies)
We have a Solaris 10 system with a solaris 9 branded zone. Trying to create a new lo interfaces i ended up rebooting the zone. The zone will not come up, it ran fine before i tried this. When i run the zoneadm -z zone-s9 boot command i get
"zoneadm: zone 'zone-s9': lo0:2: could not bring... (4 Replies)
I have two physical servers, with zones that mount local storage.
We were using "raw device" in the zonecfg to point to a metadevice on the global zone (it was not mounted in the global zone at any point).
It failed to mount on every boot because the directory existed in the zone.
I... (6 Replies)
Hi all
I have installed a demo version of SCO OpenServer 5.0.2, I finally found it is Desktop Interface, I would like to know how to change its interface to dos based interface?
If you have any ideas, please tell me then. Thank you (2 Replies)
We got a network card(e1000g0) with 1gb of speed and working with global zone. We got a new network interface card, we have to place that in slot and we have to use that card as dedicated network interface to the non-global zone(hyd_app) in V890.
As i never done this before, please explain me... (2 Replies)
Dear all,
I am a newbie in solaris and I need your advice.
I have a Solaris version 5.9 installed on Sunfire V240.
I am able to ssh the machine from putty remotely.
My problem is that I cannot see the display from KVM switch I have connected to it. I need also to be able to see the GUI... (2 Replies)
Hi,
I am attempting to configure my ethernet interface on a Sun Blade 1500. I am testing out my network interface my connecting a crossover cable from my blade to a windows box. I would like to assign an ip address of 10.0.0.2 to "bge0" and netmask of "255.0.0.0". I have typed the following:
... (1 Reply)