10 More Discussions You Might Find Interesting
1. IP Networking
four interfaces with ifconfig
all interfaces have the same mac. If is not set for unique.
but it still works.
what difference does it make to have all macs the same or different? (4 Replies)
Discussion started by: rrodgers
4 Replies
2. UNIX for Advanced & Expert Users
Hi ,
Could someone let me know how to detect duplicate ip address after assigning ip address to ethernet interface using c program (3 Replies)
Discussion started by: Gopi Krishna P
3 Replies
3. IP Networking
Hello all,
I am trying to receive (tcp/udp/sctp) traffic from all IPs and, eventually, all ports of an IPv6 address block using as few sockets as possible short of implementing my own network stack.
One possible solution was to associate an IP block to an interface then bind to that... (6 Replies)
Discussion started by: redwil
6 Replies
4. Solaris
Hi folks,
I found out the following:
provadm@BKP_LIV_NPPGW_02:home/provadm%/usr/sbin/arp -a
Net to Media Table: IPv4
Device IP Address Mask Flags Phys Addr
------ -------------------- --------------- -------- --------------------
ce5 BKP_OnM_NPPGW_02 255.255.255.255 SPLA 00:14:4f:44:e0:86... (1 Reply)
Discussion started by: kimurayuki
1 Replies
5. UNIX for Dummies Questions & Answers
I have 2 physical interfaces (bnx0 and bnx1) aggregated into aggr1. I need to assign second IP, and normally I know how to do it to physical interface (i.e. bnx0:1) however same trick (aggr1:1) is not working. Is there any way to do it? (0 Replies)
Discussion started by: bratan
0 Replies
6. IP Networking
Hi there
I lost connectivity to one of our remote systems and when I checked the messages log I found the following:
Aug 10 23:42:34 host xntpd: time reset (step) 1.681729 s
Aug 16 13:20:51 host ip: WARNING: node "mac address" is using our IP address x.x.x.x on aggr1
Aug 16 13:20:51 host... (9 Replies)
Discussion started by: notreallyhere
9 Replies
7. Solaris
hi,
how to assign static ip address to the server having solaris 10. assign static ip to nge0 which will sustain across reboots which will include all settings including gateway setting etc.. (2 Replies)
Discussion started by: pankajd
2 Replies
8. Red Hat
Dear Friends ,
I am using RHEL 5 . In my Linux Box i have two Lan cards (eth0 and eth1) .
"eth0" is connected with network 192.168.10.0 and "eth1" is connected with network 192.168.11.0 . Both Network are inter connected via routing .
Now I want a situation where , I want to dedicatedly... (2 Replies)
Discussion started by: shipon_97
2 Replies
9. IP Networking
Hi ,
by default the physical interface (eth1) and virtual interface eth1:0 will be having same mac address, is there any way we can assign separate mac addresses for both the interfaces.
would some one help me out in this.
Thanks
Gopi (1 Reply)
Discussion started by: Gopi Krishna P
1 Replies
10. IP Networking
Hi sir,
i want to make such programe which takes MAC(Ethernet) address of any host & give me its IP address.......
but i'm nt getting that how i can pass the MAC address to Frame........
Please give me an idea for making such program...
Thanks & regards
Krishna (3 Replies)
Discussion started by: krishnacins
3 Replies