Login or Register to Ask a Question and Join Our Community


Solaris

Fast Data Access MMU Miss

Login to Discuss or Reply to this Discussion in Our Community

 
Thread Tools Search this Thread
Operating Systems Solaris Fast Data Access MMU Miss
# 1  
Old 05-02-2009
Fast Data Access MMU Miss
Hi All ,


I am unable to reinstall the OS on my Ultra Sparc 10. After the 1st CD is loaded when it goes for reboot its goes to ok prompt an its unable to boot.

What could be reason for this behavior? while loading the OS its seems fine but unable to boot!!

Then i tried changing the diag-level and diag-switch and i am getting " Fast Data Access MMU Miss " .

Please help
# 2  
Old 05-02-2009
The following:
Installation - Fast Data Access MMU Miss error at the {ok} prompt
seems to imply a memory or other hardware fault although I have seen this and concluded it was caused by corrupted data either over the network (tftp boot stage).

Is your boot-device set to the correct hard disk device in the OBP?
What result do you get when you run probe-scsi-all from the OBP and is the disk you get listed the same device that the devalias for disk is set to?
# 3  
Old 05-02-2009
set-defaults at the OBP. reset-all. try boot again
Login or Register to Ask a Question

Previous Thread | Next Thread

6 More Discussions You Might Find Interesting

1. Solaris

Solaris 10 boot problem - ERROR: Last Trap: Fast Data Access MMU Miss

Hello, We have a T5140 server with Solaris 10 and its suddenly throwing "segmentation core" when I login into the server and not showing any output for commands like df, mount etc. so I had to reboot the server to fix this issue. Please note that there's no boot disk mirroring. But... (2 Replies)
Discussion started by: prvnrk
2 Replies

2. Solaris

Check kernel SHM_SHARE MMU

hiii, how can view the value of SHM_SHARE MMU on solaris 10? tnx or the answer (0 Replies)
Discussion started by: pietro1984
0 Replies

3. Shell Programming and Scripting

Do i miss counter or what

hello this script should show all users and space they used without problem : ls /home >> /root/users.txt cat /root/users.txt | while read line; do space=`du -s /home/$line` echo "$line space is $space" shift done but when i remove pipe ,script run without any output: ls /home... (4 Replies)
Discussion started by: nimafire
4 Replies

4. Ubuntu

fast data access mmu miss

hello, before i have install solaris 9, is good. I would like to install Ubuntu 10.04 on a Sun Blade 150 blade. I create cdrom iso burning with a 10x was open I made a boot ok: boot cdrom I get the following error: fast data access mmu miss i do probe-ide all reset-all always ... (2 Replies)
Discussion started by: philo_71
2 Replies

5. Programming

Read/Write a fairly large amount of data to a file as fast as possible

Hi, I'm trying to figure out the best solution to the following problem, and I'm not yet that much experienced like you. :-) Basically I have to read a fairly large file, composed of "messages" , in order to display all of them through an user interface (made with QT). The messages that... (3 Replies)
Discussion started by: emitrax
3 Replies

6. Linux

MMU exception

I hope to post in the right forum, otherwise I apologize for this. if a MMU exception is caused by a process which tries to access to other memory segment (out of its own address space) what the kernel does in this case ? maybe kernel kills the "bad" process ? (2 Replies)
Discussion started by: Puntino
2 Replies
Login or Register to Ask a Question