9 More Discussions You Might Find Interesting
1. Linux
Hello Admins,
My ask is how can I add two different subnet IPs to same box with two different gateways?
The issue is I can connect to the box when I am on ethernet LAN, but I am not able to connect to the same IP when I am on wifi. The server is RHEL 7 VM on vmware.
How can I get connected... (4 Replies)
Discussion started by: snchaudhari2
4 Replies
2. Red Hat
Dear All
I want tune my NIC's rps, rfs and xps value.
In my system I have two NIC (eth0, eth1) and I have a bond0 ( eth0, eth1).
Here is the question? Which device should I modify ?
eth0 and eth1? or just modify bond0 or modify all device (eth0, eth1, bond0)
Any advice is welcome.... (0 Replies)
Discussion started by: nnnnnnine
0 Replies
3. IP Networking
I am new in squid proxy.
My question is how to (and if it's necessary) to set one NIC for inbound traffic (http requests) and one NIC for outbound traffic (http answers)?
Thank you in advance! (4 Replies)
Discussion started by: aixlover
4 Replies
4. Solaris
I couldn't install my nic in solaris 10. I compiled and added
the driver but failed to attach the driver and ifconfig output
shows only loopback dev. Please see the following output and tell
me whether my nic has been detected and why the driver failed to
attach?
My nic is detected in linux... (0 Replies)
Discussion started by: vectrum
0 Replies
5. Solaris
-- IPMP Groups --
Node Name Group Status Adapter Status
--------- ----- ------ ------- ------
IPMP Group: hostname1.xx-xxxx.xxxi sc_ipmp1 Online ce5 Online
IPMP Group: hostname1.xx-xxxx.xxxi ipmpgrp01... (2 Replies)
Discussion started by: FeNiCrC_Neil
2 Replies
6. HP-UX
how can I determine which NIC card is virtual NIC Card
which condition can make a decision
Does HP UX have Virtual Network Adapter Concept
if ,it has
where I can Find if I Install Virutal Network Adapter
or which command that i can get it
or which software can generate
thanks (2 Replies)
Discussion started by: alert0919
2 Replies
7. IP Networking
Hi every body,
Is it possible to connect two servers Back-to-Back (Point-to-Point) using HBA adapters & using Fiber.
Note it is direct connection & there is no switches between the servers.
I'm concern about using HBA adapters, it is possible or not.
Thanks in advance. :) (3 Replies)
Discussion started by: aldowsary
3 Replies
8. AIX
Hi ,
Can you suggest me how to back to back printing in UNIX? Is there any way?
Kindly advise.
Regards
Vijaya Amirtha Raj (3 Replies)
Discussion started by: amirthraj_12
3 Replies
9. Solaris
Hi all,
I have 3 Sun v490's running Solaris 10. Each one has 2 zones on it. I changed the IP address and configuration on them this weekend, where ce0 was once the primary IP nic, now ce2 is. Previously, ce0 and ce4 were set up with IP multipathing, but I tried to remove that by changing the... (2 Replies)
Discussion started by: jackiea
2 Replies