Solaris

and can you see your disks now?

if not, hook up a screen and invoke the lsi raid utility while booting, I think it was control-c when you see the lsi screen searching for volumes.

see if you can tweak it there..

I already tried it

my LSI configuration look like-

LSI Logic Config Utility v6.16.00.00 (2007.05.07) *
* View Array -- SAS1064 *
* Array 1 of 5 *
* Identifier *
* Type RAID1 *
* Scan Order --- *
* Size(MB) 69879 *
* Status Inactive *
* *
* Manage Array *
* *
* Slot Device Identifier RAID Hot Drive Pred Size *
* Num Disk Spr Status Fail (MB) *
* 2 HITACHI H101473SCSUN72G SA25 Yes No Inactive No 69879 **
* --- Yes No Missing --- ------- **


i think status is InActive that why. But I don kno how to activate it ....

You mean you cant use keyboard strokes like "tab" and "Enter".
Basically this is similar to BIOS right?

nope ...I'm not able to use keyboard to change. Only enter for help ....where it saying no help available for the selected item.

Have you tried using fdisk to make it seen under UNIX first? Then format and devfsadm should see the disks as you expect.

i think before running fdisk solaris should see the disk using format or devfsadm command.

Hi, I have the same problem with ten differents X6250 blades. They all regognize the HD with ctrl+a (for RAID) and I theoretically could do a low level format. But when I boot an ISO image (for example Opensolaris) no HD is present. And those SUN HD are so special that you couldn't fdisk them using a SATA cable to put them via USB on a external machine.
There MUST be a tool to disable Adaptec RAID utility. I'm sure the HD is not recognized because of this.