It's not exactly a question and more of a discussion.
I found very less graphics application being developed for linux system. I'm not really fond of graphics programming and have a very little knowledge about it. Can any one suggest me that whether linux lack in ghraphics support? or... (2 Replies)
I'm having the hardest time finding the Broadcom drivers for Solaris. I need an odd ball, 32-bit for Solaris 10. Anyone know where I can find one? (0 Replies)
I use lspci and dmesg command and find out that i have ipw2000 wireless card on my laptop. I want to install driver for that but i'm not getting proper driver for that.My linux version is el5 and architecture is i386. (0 Replies)
We are seeing an odd problem on an HP dl380 running Redhat es5 (2.6.18-52+.el5). we have 3 dual channel HBA's with a single tape drive on each channel totaling six tape drives.(2 x lto3, and 4 xlto4). The problem is only a two of the lto-4s are working. At first we thought it might be hardware, but... (0 Replies)
Hi to all,
I've installed Solaris 10 on my workstation but I've some networks problems.My NIC,a Broadcom integrated chipset don't work with solaris.Whit the prtconf command I'm unable to identify the correct chipset's model.And I'm searching hovewer for some drivers but I'm fear that Broadcom... (2 Replies)
BFE(4) BSD Kernel Interfaces Manual BFE(4)NAME
bfe -- Broadcom BCM4401 Ethernet Device Driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device miibus
device bfe
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
if_bfe_load="YES"
DESCRIPTION
The bfe driver provides support for Broadcom BCM4401 based Fast Ethernet adapters.
The bfe driver supports the following media types:
autoselect Enable autoselection of the media type and options.
10baseT/UTP Set 10Mbps operation.
100baseTX Set 100Mbps (Fast Ethernet) operation.
The bfe driver supports the following media options:
full-duplex Set full duplex operation.
For further information on configuring this device, see ifconfig(8).
DIAGNOSTICS
bfe%d: couldn't map memory A fatal initialization error has occurred.
bfe%d: couldn't map interrupt A fatal initialization error has occurred.
bfe%d: failed to allocate DMA resources There are not enough mbufs available for allocation.
bfe%d: watchdog timeout -- resetting The device has stopped responding to the network, or there is a problem with the network connection
(cable).
SEE ALSO altq(4), arp(4), miibus(4), netintro(4), ng_ether(4), ifconfig(8)HISTORY
The bfe device driver first appeared in FreeBSD 5.1.
AUTHORS
The bfe device driver was written by Stuart Walsh and Duncan Barclay. This manual page was written by Stuart Walsh.
BSD July 16, 2005 BSD
