|
|
Patching Center: Systems Management Release Hub
|
|
snmpd(8n) snmpd(8n) Name snmpd - Simple Network Management Protocol (SNMP) Agent for ULTRIX gateways and hosts Syntax /etc/snmpd [ -d debuglevel logfile ] Description The SNMP Agent, performs SNMP operations on an ULTRIX gateway or host. The daemon, which is started up by an entry in the file, sits in the background and listens on SNMP port 161. When the daemon receives an SNMP packet from a Network Management Station (NMS), the daemon performs SNMP operations on the packet and returns a valid response to the NMS. The daemon extracts much of its information from kernel memory. Static variables whose values are not available in the kernel take values from the SNMP configuration file, SNMP Trap Support The cold start and authentication failure trap types are supported by The cold start trap type is generated by when is restarted. The authentication failure trap type is generated when an attempt at using a community fails. The attempt fails when an unauthorized client tries to use or the community is used in a way that the community type does not allow. The daemon sends traps to all communities specified in the configuration file with a community type The default is for the daemon to generate authentication failure traps. However, if the following clause is specified somewhere in the file, authentication failure traps are not generated: no_authen_traps SNMP Sets When the daemon receives a set-request packet, it processes the variables in the packet and verifies that they are valid read-write vari- ables. While performing this verification, the daemon constructs a linked list of the set requests. After it has completed the verifica- tion, it performs the actual set operations on the variables, as if they were being performed simultaneously. If any actual set operation fails, all of the previous set variables from the set-request packet are restored to their old values. SNMP Supported Variables For a complete listing of the SNMP Management Information Base (MIB) variables that are supported, see the Guide to Networking. Options By default, the daemon uses the command to record its error messages. However, you can obtain certain debugging and trace information by specifying the flag, the appropriate debug level, and a log file for the output on the command line. -d debuglevel logfile Outputs debugging and trace information. You can specify any one of the following debug levels with the flag: 1 Print the version number, start time, and exit time of Also print out when an SNMP packet is received, the address of the sender, and the packet size in bytes. 2 Print out what the daemon has read from the file. 3 Dump the SNMP packet that the daemon has just received and is about to process. Also print out the route and interface address that the daemon is currently looking up. This debug level also dumps the SNMP packet that the server is sending back in response to a received SNMP message. 4 Dump the variable tree. Also print out the static bootstrap array of tree information. The output for a debug level includes the information for all levels including and below the level that you specify. For example, if you specify a debug level of 3, your output includes debug information for levels 3, 2, and 1. If no debug levels are set, detaches itself from the controlling terminal and executes in the background. Restrictions Not all of the MIB variables are supported. Only the variable is settable. Files SNMP configuration file See Also snmpext(3n), snmpd.conf(5n), snmpsetup(8n) RFC 1066--Management Information Base for Network Management of TCP/IP-based Internets RFC 1067--A Simple Network Management Protocol Guide to Networking snmpd(8n)
