8 More Discussions You Might Find Interesting
1. IP Networking
I'm looking for recommendations for a general problem.
Apparently (that is according to my boss and coworkers) I am responsible for guaranteeing quality of service to our remote MySQL server during the course of the day. They may run a complete database restore for any number of reasons and are... (1 Reply)
Discussion started by: Astrocloud
1 Replies
2. IP Networking
Hello all my friends
Please Read to understand my problem
I have 1 MB bandwidth and two networks then i did traffic control on my two internal interfaces i.e eth1(192.168.3.0/24) and eth2(172.16.3.0/24) (internal) and eth0 (outside)
Then i divided my bandwidth using tc command with the... (3 Replies)
Discussion started by: rink
3 Replies
3. Solaris
Hi all,
This is a cross-post from the Sun/Oracle forums (I would include the URL here, but the forum doesn't allow me), cos quite frankly, this forum seems to be more active...
I am maintaining an in-house Sun/Oracle x86 server (x4275) running Solaris 10 with zones for testing and development... (10 Replies)
Discussion started by: boekhold
10 Replies
4. IP Networking
Does anyone know how can I determine which user is UPLOADING via http protocol? Like sending video on youtube?
Or maybe how to throttle multimedia uploads ? Or any uploads?
maybe get packet size? (9 Replies)
Discussion started by: darkman_hr
9 Replies
5. Solaris
I 'm getting following error while setting deny action for a zone.cpu-shares resource control
prctl: unable to enable deny on rctl with global flag 'no-deny' and when i check with rctladm its shows me
bash-3.00# rctladm zone.cpu-shares
zone.cpu-shares syslog=n/a ... (0 Replies)
Discussion started by: fugitive
0 Replies
6. Solaris
Hello,
I'll already apologize for my question, as it'll probably be hurting for an expert.
About two years ago I obtained a used Sun Ultra 10 with many accessoires for a very low price. I'm not much into UNIX (or rather not into it at all), but I wanted to play around a bit with it, especially as... (3 Replies)
Discussion started by: Superidiot
3 Replies
7. IP Networking
My question is such:
I want to control the bandwidth of my users and cap there speed on the network. I was told by a Cisco rep that it is better to police or control the bandwidth at the switch and not via the router. It that the correct place to control bandwidth at the switch or would it be... (0 Replies)
Discussion started by: metallica1973
0 Replies
8. Solaris
Hi all,
I have begun working on a project that involves "Crossbow" technology.
But almost immediately i have run into problems!
My version of Solaris doesnt seem to have all the Crossbow commands at all.
Eg,
when i use,
#dladm create-vnic -d nge0 1
I get the entire set of dladm command... (1 Reply)
Discussion started by: wrapster
1 Replies
install-solaris(1M) install-solaris(1M)
NAME
install-solaris - install the Solaris operating system
SYNOPSIS
install-solaris
install-solaris invokes the Solaris Install program. Depending on graphical capability and available memory at the time of invocation,
install-solaris invokes either a text-based installer or a graphical installer.
The following minimum requirements for physical memory dictate which features are available during installation:
For SPARC machines:
128 MB
Minimum physical memory for all installation types
128 MB
Minimum physical memory required for windowing system
384 MB
Minimum physical memory required for graphical-based installation
For x86 machines:
256 MB
Minimum physical memory for all installation types
256 MB
Minimum physical memory required for windowing system
512 MB
Minimum physical memory required for graphical-based installation
In some cases, even if the minimum physical memory is present, available virtual memory after system startup can limit the number of fea-
tures available.
install-solaris exists only on the Solaris installation media (CD or DVD) and should be invoked only from there. Refer to the for more
details.
install-solaris allows installation of the operating system onto any standalone system. install-solaris loads the software available on the
installation media. Refer to the for disk space requirements.
Refer to the for more information on the various menus and selections.
See attributes(5) for descriptions of the following attributes:
+-----------------------------+-----------------------------+
| ATTRIBUTE TYPE | ATTRIBUTE VALUE |
+-----------------------------+-----------------------------+
|Availability |SUNWcdrom (Solaris instal- |
| |lation media) |
+-----------------------------+-----------------------------+
|Interface Stability |Evolving |
+-----------------------------+-----------------------------+
pkginfo(1), install(1M), pkgadd(1M), attributes(5)
It is advisable to exit install-solaris by means of the exit options in the install-solaris menus.
23 Sep 2005 install-solaris(1M)