So here is a snippet from an analysis of test runs conducted in a robot experiment in the form of a table:
-----------------------------
| TN | TE | PA | PB |
-----------------------------
| Y | N | - | B |
| N | Y | A | B |
TN = Is the target north?
TE = Is the target east?
PA = Is there a passage ahead?
PB = Is there a passage behind?
How would I go about in writing a BASH script that accepts from the standard input for example:
(Straight into the terminal)
And give the output "Target is north, passage behind" for that particular example? This script must take into condition all possible scenarios when conducting the test.
Another example would be:
This would output on the standard out "Target is east, passage ahead, passage behind". If anyone can hint me in the right direction then that would be truly appreciated!
hi,
what plugins i need to install to run m4 processor in bash shell. Also, what is the file extension for m4 processor ( like .cc in c ).
Thanks (1 Reply)
Processor failed on POWER 5 machine, i have other "test" machine with different machine type, can i recover the production machine by moving its disks and HBAs to the other test machine ?? (4 Replies)
How to find out whether the system has multiple processors.
In multiprocessor system how to get their names or ids
How to send command to a particular processor ( can we use rsh) (6 Replies)
Guys...
Hows it going???
I have been going through the hardware spec of IBM system p systems.. and here i am confused
for IBM Power 520 Express it says
Processor cores:
One, two or four 64-bit 4.2 GHz POWER6 with AltiVec™ SIMD and Hardware Decimal Floating-Point acceleration
... (1 Reply)
Question is on setting of Physical and Virtual processors for LPARs to make proper use of virtualization capabilities.
Environment is a 8-way p570 with 4 LPARs.
lparVIO1 and lparVIO2:
AIX 5300-04-01
Mode/Type= Shared-SMT/Capped
Minimum Processors= 0.10
Desired Processors= 0.50
Maximum... (1 Reply)
Hi Everyone
I am new to unix. I ahve few quries that i would like to post.
Is there any way by which i get the unique processor Id. Actually i am unable to find any logic and method to get access to Processor Id.
Is it possible to get it. I read it on Intel site that the new processor do no... (1 Reply)
From a PROM ok prompt I have typed banner. This returned this info
SunSPARCStation20 (1X390Z50) ......
Okay, I read that the 1x390z50 is the processor type. How can I found out the speed of these processor? Is it 50mhz? Don't know but I am curious. Thanks (5 Replies)