10 More Discussions You Might Find Interesting
1. UNIX for Dummies Questions & Answers
Hi!
I am not sure if this is the right place to post this question. What I did was to download vmware onto my laptop, them install a linux distro as a guest O.S., on VM network configuration I have used "bridge", them I used Virtual Network Editor to chose the network interface, but as I write... (4 Replies)
Discussion started by: fretagi
4 Replies
2. Red Hat
Hi, Earlier we used to reboot servers based on adhoc request, never checked anything on it pre-reboot., But now i need to reboot regularly but most of the info is not available, I need to know want to make sure that server to be rebooted without any issues, so I want to do few prechecks which will... (5 Replies)
Discussion started by: nanz143
5 Replies
3. AIX
Hello Everyone
We have purchased IBM Pureflex chassis with 5 P460 blades. We have configured each blade with dual vios and 4 vio clients. VIOS installation and vio client installation and configuration was completed successfully.
When we tried to connect the network cables from Pureflex... (2 Replies)
Discussion started by: yuvarakasil
2 Replies
4. HP-UX
Newbie with UNIX here.
Currently troubleshooting a UNIX terminal we have.
I determined it to be bad and swapped it out with a known good terminal. I went in and changed the IP address and host name to reflect the old terminal. Although now there is no connectivity.
I swapped out the NIC... (1 Reply)
Discussion started by: kevinlord190
1 Replies
5. UNIX for Dummies Questions & Answers
red hat 5 update 4 64bit. linux newby. on an interactive boot i can ping -t my vm linux server from my physical MS XP workstation and a vm W2000 64 bit server until xend is started, after that i get destination unreachable. if i choose not to start xend on the interactive boot i retain... (1 Reply)
Discussion started by: slartibartfast9
1 Replies
6. UNIX for Advanced & Expert Users
Hi guys,
I had two computer which is one with vista and other one with fedora and they are connected via one router.
from vista to fedora is fine.. I can ping or connect via putty using Ip address but I couldn't connect putty using hostname/domain.
If I typed in fedora the hostname,... (0 Replies)
Discussion started by: peac3
0 Replies
7. Solaris
I have a solaris 10 x86 installed on a VMware server. It has been runing well for a couple weeks, but started to have network connectivity issue since last week. The network card seems to be up and down every one minute. So I got connection closed after I sshed to it for about one minute.
#... (2 Replies)
Discussion started by: fredao
2 Replies
8. AIX
AIX Guys!!!
What pre-checks would you do on a 5.3 server before TL/SP/APAR installation?
Bala (2 Replies)
Discussion started by: balaji_prk
2 Replies
9. Solaris
I have 4 V440 servers running Solaris 9. I have their interfaces configured (ce0) and have connectivity to our network. However, after reboot,...the connectivity is lost although the interface shows that its still up after an ifconfig -a.
Only after I reconfigure the interface do I restore... (19 Replies)
Discussion started by: StorageGuy
19 Replies
10. IP Networking
Hi,
I would like to know how i can setup my unix computer to connect to novell. Anybody any idea? (5 Replies)
Discussion started by: edw1ns
5 Replies