10 More Discussions You Might Find Interesting
1. Red Hat
I have a Red Hat Linux 5.9 Server installed with one hard disk & 2 Partitions created on it as follows,
/boot - Linux Partition & another is
LVM - One VG & under that 5-6 Logical volumes(var,opt,home etc).
Here my requirement is to take out 1GB of space from LVM ( Any logical... (5 Replies)
Discussion started by: gr8_usk
2. Filesystems, Disks and Memory
I would like to know different between soft partition concept and hard partition concept on solaris.
Here is little explanation between soft partition concept and hard partition concept on solaris.
1TB total space available in storage in all mapped to the OS to... (2 Replies)
Discussion started by: edydsuranta
while formatting hard disk i am getting following error.
Partition 1 ends at 266338338
It must be between 34 and 143374704.
label error: EFI Labels do not support overlapping partitions
Partition 8 overlaps partition 1.
Warning: error writing EFI.
I have formatted the... (2 Replies)
Discussion started by: nikhil kasar
4. UNIX for Dummies Questions & Answers
Just started understanding linux filesystem and partition utilities.
I was going though some video tutorials by CBT nuggets and the author was cursing fdisk as fuzzy tool and recommending to use parted instead.
In our job environment i have seen almost every one using fdisk utility for... (1 Reply)
Discussion started by: pinga123
5. Shell Programming and Scripting
Please move if I have chose the incorrect forum section. I am trying to move data that is not backed up from partition 1 to partition 2 on a SAN that has a GFS2 filesystem. Since the data is not backed up I am rsyncing this data and once verified I will delete from the source... (6 Replies)
Discussion started by: jaysunn
I want to use GNU parted for disk partition, but I also hope to get the partition type id by parted. :confused:I can get it from fdisk -l, but I don't know how the parted can get it. The print of the "parted print" only include fstype flags and so on, I hope some help. Thank you.
My English is not... (2 Replies)
Discussion started by: ZR_Lang
7. Filesystems, Disks and Memory
I have a RHEL system with two 500GB hard drives in RAID 1 (I think hardware, but not 100% certain - any way to tell?).
It looks like it was just set up in default configuration with a small boot partition and one huge partition for the rest, which composes a LVM volume.
I want... (1 Reply)
Discussion started by: builder88
8. UNIX for Dummies Questions & Answers
I've created a partition with GNU Parted, how do I mount the partition?
The manual information at http://www.gnu.org/software/parted/manual/parted.html is good, but I am sure about how I mount the partition afterwards.
--Todd (1 Reply)
Discussion started by: jtp51
So, I burned the 5 cds of SuSE 10.1, and would really like to begin installation.
But when I get to the partitioning phase, I get an error message saying the first hard drive is unreadable by parted, and that I'll have to use Yast instead. It also tells me I wont be able to move delete... (0 Replies)
Discussion started by: Mudrack
10. UNIX for Dummies Questions & Answers
1) is logical partition the same as physical partition except that one is physical and the other is logical?
2) then it must a one to one ratio? (3 Replies)
Discussion started by: yls177