Haha yeah it works, I already put in the '.txt' and the correct paths.
just dont know how it works...
---------- Post updated at 11:26 AM ---------- Previous update was at 09:34 AM ----------
OK,
remember how i said there is a Master file...
and from this i strip data out to produce another file...
and from this i strip more data out to get Mainfile.txt
and when i ran the array it somehow looked in Mainfile.txt and it all tallied up correctly.
well now i've tried using a different Master file. All the changes filter through all subsequent steps
until it gets to the array part - and it is still outputting the same data as before
.i.e it is still looking in the same place for it's data.
Is there any way i can explicitly state to look in mainfile.txt?