Search Results

I have to install C compiler on Redhat 9. I was told that its on the install CDs however, I cannot find it. Would appreciate any help on this issue.

Thanks Pressy. I found out that this behavior is a solaris
default. Multipathing software would be needed to allow
failover of both interfaces.

[gamwsm02]:#ifconfig -a
lo0: flags=1000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4> mtu 8232 index 1
inet 127.0.0.1 netmask ff000000
ce0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu...

Would anyone know why a V440 Solaris 9 machine's interfaces (ce0 and ce1)
will not failover?

Both interfaces are on the same subnet, but different IPs. I can pull the plug on once interface...

Unbeliever,...all interfaces have different ethernet addresses. I changed the setting from the boot prom a while back. IPs are not the same.

To reiterate, I configured all 10 of these machine's...

Unbeliever,..There was only one interface when I started this post. Now there are 2,.....on the same network, but no autofailover. Both are plugged in.

RTM,....all the startup scripts have rwx permissions for root.
And yes,..when I downed ce1,...ce0 started working.

RTM,....all 4 machines have 2 nics. There are no relevant errors logged. These machines are not clustered. They are individual DNS servers.

PPASS,....netconfig exist on all machines.

I tried...

REBORG,...ifconfig ce0 + netmask + produces the following output.

ifconfig: + :bad address

I'm have a zero on /etc/hostname.ce0. Same as the other 10 V440s.
Netmask is correct. Same on all...

Networkfre@k, thanks for your reply.....both server and switch are set to 100 Full Duplex.

Unbeliever, thanks for youre reply. Both hosts and hostname.ce0 are correct. I have the subnet listed...

I have 4 V440 servers running Solaris 9. I have their interfaces configured (ce0) and have connectivity to our network. However, after reboot,...the connectivity is lost although the interface shows...