Search Results

Based on the documentation (Help - AIX 6.1 Information Center (http://pic.dhe.ibm.com/infocenter/aix/v6r1/index.jsp?topic=%2Fcom.ibm.aix.cmds%2Fdoc%2Faixcmds5%2Fsar.htm)), I should be able to get the...

Here's an update.

I tried to use DHCP and it worked! Then I reconfigured it back to use static IP and it stopped working again. After a while, it just started working :confused: I don't have...

Hey guys, thanks for all the responses :)

As I was reading through the post, going through the settings, I found a discrepancy between my non-working LPAR & the working one:

Under Hardware...

That's alright zaxxon. Thanks for the quick responses :)

I'm just really frustrated...I don't have a lot of experience with AIX. I have a little more experience with Solaris and it's almost...

I'm 99% sure 10.1.40.1 is external because my non-LPAR systems use that gateway as well.

How do I know if an LPAR is using a SEA? I know I have a SEA because on the VIO Server...

$ lsmap...

Yes, 10.1.40.1 is a gateway and it's up and running. My other systems using that as the default GW is up.

How do I check that on the command line?

In the HMC, I was able to graphically confirm that the LPAR is on the same VLAN as another LPAR that is connected to the network, but on a different...

I can't ping even the default GW. You will notice it says 100% packet loss.

10.1.40.41 is the IP of the LPAR I'm trying to setup. It only exists in my private network.

So I have created an LPAR. I think I have configured everything properly but I can't ping the network. The LPAR is on a VLAN. Other LPARs on the same VLAN works. Here's some info on the LPAR:

...

iostat -En
The output is difficult to reliably script to parse the number of hard drives.

prtconf
Similar to iostat. It's difficult to reliably script to parse the number of hard drives.

The...

I think you are right:

# rmformat
Looking for devices...
1. Logical Node: /dev/rdsk/c1t0d0s2
Physical Node: /pci@7c0/pci@0/pci@1/pci@0/ide@8/sd@0,0
Connected Device:...

Thanks for the link h@foorsa.biz.

I tried running it on my system and it shows this:
c0t0d0s0 --- sd0
c0t2d0s0 --- sd1
c1t0d0s0 --- sd2

...and when I ran "format", it shows this:

# format...

Thanks for the replies!

I should clarify what I'm trying to do...I'm trying to write a script to do some simple monitoring. I want to cron and execute it as non-root. Executing those commands do...

I'm trying to figure if there are commands I can run as non-root/non-privileged users to figure out the number of disks. I know I can use format but it needs root. Any idea?