Search Results

Hi there,

I need help regarding RAID 5. I created a metadisk device RAID 5 and I have been having problems with it. One slice is currently under Maintenance and the other one is Last Erred. The...

OH MY GOD!!! I DID IT!!!!!!! Thank you so much!!!!!!! :-)

I will try that. I will need a SCSI cable that has one 68-pin Ultra SCSI connector on one end and the other end is the smaller one, right?

Hmm is the hvd scsi controller then a PCI card that I will need to install on both SunBlade 2000s?

So what i did was to connect each of the SCSI cable from the D1000 to the SCSI connector located next to the parallel connector just below the two serial connectors. I am trying to figure out if...

Oh wait a minute, should I do the prtdiag on the D1000 itself or one of the two hosts? I will look into the documentation.

oh I do not see anything about bus. What I see is CPU, IO Devices, Memory Configuration. In addition, what I have is an 8-disk D1000. On the Option Switch at the back. I set it to

1 - down
2...

For host 2 as an example, this is what I got.

================================= IO Devices =================================
Bus Freq Slot + Name +
Type MHz Status Path ...

When I did probe-scsi-all, what I got is the following.

{0} ok probe-scsi-all
/pci@8,600000/SUNW,qlc@4
LiD HA LUN --- Port WWN --- ----- Disk description -----
1 1 0 2100000c50ab7ed5 ...

When I looked at sd.conf on both hosts, I see that they are both targetted at 7. Should I change one of them to be different? After I connected both SunBlades to the D1000, I did try devfsadm but...

Hi there,

I have two SunBlade 2000s that I want to connect to a single D1000. I am told that I need to do a split bus mode. I don't really understand what that means. Does that mean that half...

I am trying to configure a SunBlade 2000 for use in a network. We received it from a different location previously and so it still had its previous hostname and other network configurations. I...

What I mean to say is do I install an Ethernet cable to TPE and to the main patch panel and then set up a Jumpstart server to boot? I have entered the MAC address in the NIS map. I tried doing...

Hi guys,

I have a SunBlade 2000 that I am trying to configure. It has been configured previously with an IP address, hostname, DNS and so forth. I want to configure it with a new IP address. ...