Login or Register to Ask a Question and Join Our Community


SCO

SCO 5.0.7v VM Hardware

Login to Discuss or Reply to this Discussion in Our Community

 
Thread Tools Search this Thread
Operating Systems SCO SCO 5.0.7v VM Hardware
# 1  
Old 10-14-2014
SCO 5.0.7v VM Hardware
I run SCO 5.0.7v in ESXi 5.5 and am looking at ways to increase performance. I notice that the VM hardware is still set to 4 and wondered if there was an advantage in raising it or will this cause issues?
Login or Register to Ask a Question

Previous Thread | Next Thread

3 More Discussions You Might Find Interesting

1. SCO

Recommendation for hardware to run SCO OSR 5.0.7 natively

Looking for a modern server to run SCO OSR 5.0.7 without VM (native), h/w must have manufacturers warranty. Requirements would be to accommodate light loads of up to 15 users, app does not take more than 30 - 40 MB of RAM and data stored takes up to 15 - 20 GB, no internet connections... (3 Replies)
Discussion started by: migurus
3 Replies

2. Solaris

Hardware faulty, but which hardware?

Hi folk, I have this hardware faunty message, but dont know which hardware is this ? can you guide me ? --------------- ------------------------------------ -------------- --------- TIME EVENT-ID MSG-ID SEVERITY ---------------... (9 Replies)
Discussion started by: dehetoxic
9 Replies

3. SCO

Migrate SCO 5.0.6 to different hardware

hi Howto migrate SCO Unix 5.0.6 to different hardware? I'd like to try using Acronis. Which Acronis Version support SCO Unix 5.0.6? (14 Replies)
Discussion started by: ccc
14 Replies
Login or Register to Ask a Question

LEARN ABOUT LINUX

mkfs.bfs

MKFS.BFS(8)						Linux System Administrator's Manual					       MKFS.BFS(8)

NAME

       mkfs.bfs - make an SCO bfs filesystem

SYNOPSIS

       mkfs.bfs [-N nr-of-inodes] [-V volume-name] [-F fsname] device [size-in-blocks]

DESCRIPTION

       mkfs.bfs creates an SCO bfs file-system on a block device (usually a disk partition or a file accessed via the loop device).

       The  size-in-blocks  parameter  is  the	desired size of the file system, in blocks.  If nothing is specified, the entire partition will be
       used.

OPTIONS

       -N     Specify the desired number of inodes (at most 512).  If nothing is specified some default number	in  the  range	48-512	is  picked
	      depending on the size of the partition.

       -V volume-label
	      Specify the volume label. I have no idea if/where this is used.

       -F fsname
	      Specify the fsname. I have no idea if/where this is used.

       -v     Be verbose.

EXIT CODES

       The exit code returned by mkfs.bfs is 0 when all went well, and 1 when something went wrong.

SEE ALSO

       mkfs(8).

AVAILABILITY

       The mkfs.bfs command is part of the util-linux package and is available from ftp://ftp.kernel.org/pub/linux/utils/util-linux/.

Util-linux 2.9x 						   12 Sept 1999 						       MKFS.BFS(8)