SCO 5.0.7v VM Hardware

3 More Discussions You Might Find Interesting

1. SCO

Recommendation for hardware to run SCO OSR 5.0.7 natively

Looking for a modern server to run SCO OSR 5.0.7 without VM (native), h/w must have manufacturers warranty. Requirements would be to accommodate light loads of up to 15 users, app does not take more than 30 - 40 MB of RAM and data stored takes up to 15 - 20 GB, no internet connections...

2. Solaris

Hardware faulty, but which hardware?

Hi folk, I have this hardware faunty message, but dont know which hardware is this ? can you guide me ? --------------- ------------------------------------ -------------- --------- TIME EVENT-ID MSG-ID SEVERITY ---------------...

3. SCO

Migrate SCO 5.0.6 to different hardware

hi Howto migrate SCO Unix 5.0.6 to different hardware? I'd like to try using Acronis. Which Acronis Version support SCO Unix 5.0.6?

LEARN ABOUT FREEBSD

brandelf

BRANDELF(1)						    BSD General Commands Manual 					       BRANDELF(1)

NAME

     brandelf -- mark an ELF binary for a specific ABI

SYNOPSIS

     brandelf [-lv] [-f ELF_ABI_number] [-t string] file ...

DESCRIPTION

     The brandelf utility marks an ELF binary to be run under a certain ABI for FreeBSD.

     The options are as follows:

     -f ELF_ABI_number
	     Forces branding with the supplied ELF ABI number.	Incompatible with the -t option.  These values are assigned by SCO/USL.

     -l      Writes the list of all known ELF types to the standard error.

     -v      Turns on verbose output.

     -t string
	     Brands the given ELF binaries to be of the string ABI type.  Currently supported ABIs are ``FreeBSD'', ``Linux'', and ``SVR4''.

     file    If -t string is given it will brand file to be of type string, otherwise it will simply display the branding of file.

EXIT STATUS

     Exit status is 0 on success, and 1 if the command fails if a file does not exist, is too short, fails to brand properly, or the brand
     requested is not one of the known types and the -f option is not set.

EXAMPLES

     The following is an example of a typical usage of the brandelf command:

	   brandelf file
	   brandelf -t Linux file

SEE ALSO

     The Santa Cruz Operation, Inc., System V Application Binary Interface, http://www.sco.com/developer/devspecs/, April 29, 1998 (DRAFT).

HISTORY

     The brandelf manual page first appeared in FreeBSD 2.2.

AUTHORS

     This manual page was written by John-Mark Gurney <jmg@FreeBSD.org>.

BSD
								  March 25, 2014							       BSD

SCO