9 More Discussions You Might Find Interesting
1. UNIX for Dummies Questions & Answers
I have to install unixware 7.1.1 on an intel server which does not have an on board floppy disk. I ahve got a USB floppy drive. how could I provide HBA driver using this usb floppy drive?? (2 Replies)
Discussion started by: siddhartha7m
2 Replies
2. SCO
can not for the life of me workout which BTLD to load allways shows no HDD available can any one give me a clue
tried
hpsas
aacraid
lsil
a160
a320
server is a ML310 G4 ?????:confused::confused: (7 Replies)
Discussion started by: wildginger
7 Replies
3. SCO
we are installing Openserver 5.0.7, system have SAS controller (Hard Disk Attached) as well as Adaptec ultra 320 controller (Tape Drive Attached).
At the time of installation we link both driver BTLD
Boot: Defbootstr link=accraid ad320
Aftes succesfully installation of accraid btld... (6 Replies)
Discussion started by: hafizurr
6 Replies
4. SCO
Hi everyone,
We r installing sco openserver 5.07 on dell poweredge 2800 but we are facing problem when installing SCSI-raid drivers. Dell provide Perc4 raid card and we dont found raid drivers for this specific raid card. So we r stuck up on primary stage and we also dont know the... (2 Replies)
Discussion started by: mineshkoli
2 Replies
5. SCO
Hello, i'm mostly a linux person, so I have some experience in unix. I don't even know where to start with unixware though. I boot, anwser a couple questions in the installer, and when it comes to detecting and loading the drivers, it hangs as 90% when loading "IDE". I press crtl-alt-esc and it... (1 Reply)
Discussion started by: techmaster
1 Replies
6. SCO
Hi All,
I just tried to intall Unix ware SCO version 7 on my computer but when system first boots from the CD The terminal Emulator does not shows texts in correct form; it shows all the text in Obnoxious form which is unable to read. I have ATI Radeon 9000 Graphics card installed on my... (0 Replies)
Discussion started by: monster12
0 Replies
7. UNIX for Dummies Questions & Answers
I tryed to install SCO 5.0.6 OpenServer on P4 2.0 GHz 384 MB ram 40 GB HDD. It booted from the floppy disk, and when it comes to hd_config I got this error:
unexpected trap in kernel mode:
PANIC: K_trap - kernel mode trap 0x0000000E
** Safe to power off **
Please, what should I do? (1 Reply)
Discussion started by: Guest07
1 Replies
8. UNIX for Dummies Questions & Answers
I got serious problem with installation of Unixware 7 on simple Intel p166 machine. Got Maxtor 850mb HDD. Everytime i try to install the system (through all install diskettes, including HBA) i got panic:
PANIC: kernel-mode address fault on user address ...
...with registers and hardware stack... (1 Reply)
Discussion started by: nalim
1 Replies
9. Filesystems, Disks and Memory
I am using SCO Unixware 2.1 & some PC clients are connected, suddenly one message appearslike :
UX:strintercept error: dropping message
this message starts coming repeatedly & agtre some time system hangs.I had to reset the system & now the problem is not there.Please suggest, why this is... (0 Replies)
Discussion started by: paprch
0 Replies
