Hopefully this is just a quick one - but you never know.
I have/had a Centos Cluster running a Netbackup server - I've had an outage and we seem to have lost a node. As a consequence I'm in a bit of a quandary, not familiar with this software either.
The server is a Dell PowerEdge 1950 running Centos 5.4 with the kernel 2.6.18-164.11.1.el5PAE #1 SMP and wait for it a back ported GFS for compatibility.
I've managed to get the system back and the GFS disk mounted by hacking the /etc/cluster/cluster.conf file as follows - the original file first.
This was changed to;
When I run clustat I see the following.
Although the disks have come back, the cluster doesn't seem to be up - is there anything else that I should be looking at. The networking hasn't started properly as I'm not seeing the clustered IP's so here is the output of ifconfig.
So I guess the question is, what should I start with - if I want to boot this cluster as single node - how should I go about it. Are there any other changes that I should make to the cluster.conf file? Or are there any other files that I should be changing as well - any help here would be really appreciated.
Unfortunately I have a dentists appointment, but I'll be back online a little later - but out of the office. However if there are any other files I have to look at or change, I'll be doing that first thing in the morning.
Hi,
I installed Solaris 10 recommended patch cluster (patch bundle of 400+ patches). After reboot global zone is fine, but a lot of services was in uninitialized state. I had to run /lib/svc/bin/restore_repository and then services came online.
Now I can't login to server with NIS account... (1 Reply)
Hallo to everyone.From sometime i have problems with my asterisk pbx on cent os which is in corosync cluster mode with resource groups.The problem is for time the cluster just swap the active one with the other and the only messages in \var\log\messages is that bond0:link status defenitly down for... (0 Replies)
Any help appreciated just logging in to this server which is a front end for Rocks Cluster 6.1.1. Getting the below errors:
ldconfig
ldconfig: /usr/lib/libX11.so.6 is not a symbolic link
ldconfig: /usr/lib/libjpeg.so.62 is not a symbolic link
ldconfig: /usr/lib/libpng12.so.0 is not a symbolic... (3 Replies)
Dear Linux Experts,
On my windows 7 desktop with the help of Vmware workstation (Version 7.1),
created virtual machine and installed Centos 5.7 successfully using ISO image.
Query : Is this possible to upgrade the Centos 5.7 using Centos 5.8 ISO image to Centos version 5.8?.. if yes kindly... (2 Replies)
Hello experts -
I am planning to install a Sun cluster 4.0 zone cluster fail-over. few basic doubts.
(1) Where should i install the cluster s/w binaries ?. ( global zone or the container zone where i am planning to install the zone fail-over)
(2) Or should i perform the installation on... (0 Replies)
Hi all, i have 3 nodes cluster (Centos 5 cluster suit) with out quorum disk,
node vote = 1,
the value of a quorum = 2,
when 2 nodes going offline, cluster services are destoys.
How i can save the cluster and all services(move all services to one alive node)
with out quorum disk when other... (3 Replies)
Yesterday my customer told me to expect a vcs upgrade to happen in the future. He also plans to stop using HDS and move to EMC.
Am thinking how to migrate to sun cluster setup instead.
My plan as follows leave the existing vcs intact as a fallback plan.
Then install and build suncluster on... (5 Replies)