Every connection is successful, there is a timeout set but does not seem to be affecting this. As soon as we connect we run an ls command which is successful and less than a second later you run the ls command again and getting the message that you have been disconnected from the server.
This happens after any/every data transfer whether it is ls/dir/put/get, you only get a single data transfer and then you are disconnected.
Using HP-UX previously there was no issue, there has been no change to the ftp server, windows desktops can connect and do not get disconnected, i am also getting the same issue with OEL5.5 servers.
This is not a network/firewall issue as all the network settings are the same for every client we use. It is not an issue with active or passive mode as both modes show the exact same symptoms. However testing ftp from the linux client we can connect to every other ftp site without issue both within and external to the firewall and do not get the same error.
Can anyone suggest why this may be happening? Could it be due to the version of ftp we are using?
My SSH to server got frozen after idle for a couple of hours.
My related configuration are:
In my /etc/ssh/sshd_config:
------------------------------------------
ClientAliveInterval 30
ClientAliveCountMax 4
TCPKeepAlive yes
------------------------------------------
and my ~/.ssh/config:... (6 Replies)
getting error as below while executing script in linux.
OS version:
Linux VGP-3GPSDB-LX 3.10.0-514.el7.x86_64 #1 SMP Wed Oct 19 11:24:13 EDT 2016 x86_64 x86_64 x86_64 GNU/Linux
./imxtract.sh: line 395: unexpected EOF while looking for matching ``'
./imxtract.sh: line 402: syntax error:... (1 Reply)
Hello,
I have enabled defaultfixed and added the net0 per the solaris 11 documentation. I'm able to ping outside like google and internally but I'm just not sure why the gnome network utility shows wired(net0) as disconnected. Any ideas? Thank you
---------- Post updated 04-08-15 at 08:47 AM... (0 Replies)
Hi,
I have a few questions.
There is a CORBA connection between 2 HP-UX 11.11i hosts.
Then the LAN of the 2nd host is pulled.
On the 1st host all connections disappear, as expected.
But on the 2nd host all connections still are present, as established.
With lsof one can see that the... (2 Replies)
Hi all
This is my first post in this forums. I hope some one can help me with this
my Sun Ultra 60 worked fine couple of months back when i used a dell (1280x1024). i move to a MN last month n bought a new sony monitor with (1280x1024) but when i connect it to the box it monitor displays... (1 Reply)
HI,
In unix we can get profile on a c program like this ::
cc -g -p -o cpp_sw_gsmconverter_shailesh5 cpp_sw_gsmconverter_shailesh5.c
prof cpp_sw_gsmconverter_shailesh5
In the same manner how can I collect statistics in linux using gcc command.
Thanks in advance. (1 Reply)
Hi all, can someone tell me the easiest was to get disk info from a console.
I manage headless servers, and would like to collect the specs on hard drives installed without looking it up through Sun.
The boot messages only tell me the size/name e.g. 'Sun36G'
I want to know the rotation... (1 Reply)
Hi Guys...
I have a problem of getting multiple LogWatch mails from my box. I have a cron setup to send me (and some other users) Logwatch report mail form our server. I end up getting multiple mails from all the boxes (other users have not complained of this). I cannot figure out why. I... (0 Replies)