Hi All,
I have one situation to shut-down the system through shell script.I need script command to shut-down the system and process should end(safe-mode) the MyEclipse.
I am having exactly the same problem with https://www.unix.com/programming/129264-application-cleanup-during-linux-shutdown.html but the thread is old and closed. The only difference is that I use sigaction() instead of signal(), which is recommended, as far as I know.
This is my code:
... (9 Replies)
Hello,
from last few days my laptop is not whutting down properly.. when ever i ty to shutdown it restarts again.. what may be problem?? antivirus is updated till date.. and i use windows xp sp2....
regards,
deepak. (5 Replies)
I am working on a SUN T2000 machine with Solaris 10 running on it. When I checked the system this morning, I found it to be turned off. The lastreboot command showed that the system had been shut down the previous night.
I want to find out how the system was shut down. I have run hardware health... (2 Replies)
Ok here is the problem we have 2 v440 with same IP address running solars 9. one remains on the other remains off. They are both configured exactly the same for redundant purposes for the software we use. This was the best/worst idea. Great because down time is only a mere minutes. The bad is the... (7 Replies)
rc0(8) System Manager's Manual rc0(8)NAME
rc0 - Runs command script executed when stopping the system
SYNOPSIS
rc0
DESCRIPTION
The rc0 script contains run commands that enable a smooth shutdown and bring the system to a single-user state; run levels 0 and s. In
addition to commands listed in within the script itself, rc0 contains instructions to run commands found in the /sbin/rc0.d directory. The
script defines the conditions under which the commands execute; some commands run if the system is being shut down while others run if the
system is being shut down and rebooted to single user.
By convention, files in the /sbin/rc0.d directory begin with either the letter "K" or the letter "S" and are followed by a two-digit number
and a filename, for example: K00enlogin K05lpd K60cron K30nfs
In general, the system starts commands that begin with the letter "S" and stops commands that begin with the letter "K." The numbering of
commands in the /sbin/rc0.d directory is important since the numbers are sorted and the commands are run in ascending order. Files in the
/sbin/rc0.d directory are normally links to files in the /etc/init.d directory.
An entry in the inittab file causes the system to execute the rc0 script, for example: ss:Ss:wait:/sbin/rc0 shutdown < /dev/console >
/dev/console 2>&1 s0:0:wait:/sbin/rc0 off < /dev/console > /dev/console 2>&1
The following operations are typical of those that result from executing the rc0 script and the commands located in the /sbin/rc0.d direc-
tory: Notify users that the system is shutting down. Sync the disks Stop system services and daemons Stop processes Kill processes Unmount
file systems Invoke init if the system is being shut down to single user
The killall command sends a SIGTERM signal to stop running processes; SIGKILL follows to kill all processes except the process which initi-
ated the call. The umount -a command unmounts all file systems except the root file system.
FILES
Specifies the command path Specifies the directory of commands that corresponds to the run level
RELATED INFORMATION
Commands: init(8), killall(8), rc2(8), rc3(8), shutdown(8) delim off
rc0(8)