9 More Discussions You Might Find Interesting
1. Infrastructure Monitoring
After setting up MQTT and testing some ESP8266 and ESP32 modules, where I noted that testing in Programming ESP32 (ESP-WROOM-32) as an MQTT Client Subscribed to Linux Server Load Average Messages, I was so impressed with MQTT that I installed MQTT on three different computers, instantly and... (2 Replies)
Discussion started by: Neo
2 Replies
2. IP Networking
My son does homework on a school laptop. I was thinking about setting up a gateway on my home network, so that I can monitor web traffic and know if he is doing his homework without standing over his shoulder. Ideally I would like to use the Raspberry Pi Model b that I already have. However, I... (15 Replies)
Discussion started by: gandolf989
15 Replies
3. Emergency UNIX and Linux Support
Hi all,
I need to add domain and search parameters to resolv.conf, however network manager overwrites.
Setting the PEERDNS=No in the interface file seems to have no effect on this behaviour.
Sadly I cannot just disable NM as these are not my hosts, I'm just attempting to install a platform... (3 Replies)
Discussion started by: Skrynesaver
3 Replies
4. Web Development
Hi All,
Frankly I'm new to Linux Environment. While we are trying to Host an ASP.NET 5 Web Application on Centos OS7 Web hosting Server. There were couple of steps which we are supposed to go through, please see this link -
We are stuck at Create a Container & then Running the Container,... (1 Reply)
Discussion started by: John Fredric
1 Replies
5. Red Hat
I was testing Networking Teaming (activebackup) with a VM hosted on VmWare Workstation and VirtualBox, and the result is, if the active interface is down, the system is not using the backup interface.
Tested on both CentOS / RHEL 7
Please find below the command I have used to configure teaming.... (0 Replies)
Discussion started by: atanubanerji
0 Replies
6. AIX
I have configured a custom application monitor with restart count = 3.
say the application has restarted 2 times, if the application fail 2 more times within restart interval, it will failover.
Is there any counter to tell me the recent restart count?
Thanks!! (1 Reply)
Discussion started by: skeyeung
1 Replies
7. Programming
I am trying to make a server and client, the client will choose between some options and the server will react accordingly.
After a some reads and writes that work the server needs to read from client an INT i use this:
read(newSd,&k,sizeof(int));But even if all the other times there was no... (1 Reply)
Discussion started by: theSling
1 Replies
8. Linux
Hi,
For some reason my network card started going 10Mb/s half duplex instead of 1000Mb/s full duplex. System is connected to 8x1Gb HP switch.
Other devices connect fine through the switch and get full 1Gb network.
I have Centos 5 with all updates. Driver comes from elrepo and as well is... (1 Reply)
Discussion started by: columb
1 Replies
9. Programming
I am developing a Network Appliation to monitor computers in a network.
Specs are
App monitors the current web page viewed in each system
App also can shutdown the computer in the network
App can show all process run by each computer in the network
I am now confused how to start my... (2 Replies)
Discussion started by: valaparambil88
2 Replies