Search Results

Although this will allow you have more space for your current problem it is not going to clean out stuff on your root filesystem leading to the same space problem down the road in other places as log...

One of my (now ex) customers had a similar situation with his accounting software. When I finally got to a support person who knew the software it turned out that the program was tied to the system...

Along with the above it might be good to have an idea of how the hard disk is arranged. Accomplished with divvy /dev/harddiskname. Also would help to know what accounting program or how it is set up...

no problem. ftp to the ip address.

I just loaded one and no issues.

I still support 2 systems that will need to be loaded but will download the patches first.

The 3 major applications installed on 3 customers I supported transferred across without any problems. It was a matter of backing the programs and data to tape, loading the enterprise system, and...

Located. See private message.

mountable most likely would be ds18.

I create a mount point called fd0 on root so that addressing it is at fd0.

I fought a battle long ago with the 5.0.5 boot floppy. As supplied, it is corrupt and the solution was to use a 5.0.4 boot floppy. This was confirmed by the Compuserve support group for SCO stuff,...

Running the login process for the various ttys at the speed specified.

If you were to change to one of the alternate screens you would find the login: prompt waiting for you.

If you were to be...

See a private message.

You will eventually find that the cost in time for data transfer over direct connect will many times exceed the cost of an ethernet card and patch cord.

You can do it with serial ports and a...

PM your email address, please.

And the operating system?

IIRC, the change from GUI to command line is handled by modification of /etc/init in the activation line for tty01.
Switching between the 12 ttys on the console keyboard is normally [ALT][Fkey] but...

Earlier versions required the password at that point to go into single user mode.

How about from multi-user, can you issue the init from a command prompt?

Probably not a kit, but at least a copy of the CD. I'll PM later today or tomorrow when I get into the pile.

I've never done it under a windows environment but with the right terminal emulator you can embed control codes at the beginning and end of the print job to switch the emulator from screen dump to...

From release notes:
choose SCSI CD-ROM
select wd for ha type
if on primary IDE select 0 for HA#
if on secondary select 1 for HA#
if master 0 for SCSI ID
if slave 1 for SCSI ID
0 for SCSI LUN...

If you have the install media with floppy you can boot with the floppy, at boot: type tools. This will load the OS into memory and allow you to run the fsck /dev/hd0root.