Search Results

You will see a prompt to enter the raid configuration process during the system POST.

The technique that you are using is only likely to work if the source and target machines are identical, both hardware and cmos/raid configuration.

You will have to supply a lot more information first.
How did you create the image, and what is the hardware configuration of that machine?
How did you configure the RAID on the new machine, and...

You haven't added the Broadcom device yet? Is this because you tried, and the device is not either of the ones for which there is a SCO driver.
HP does not have any SCO drivers for the z400.
For...

Well, there's definitely a discrepancy between the adapter named in post#5 (/dev/mdi/bnxii0) and the one you show in the screenshot (/dev/mdi/r9e0)!
Which is the one in question?

What happened when you ran netconfig?

What steps did you take after installing all that software?
Some possibilities:
The nic is disabled in the CMOS.
netconfig requires that you input the PCI parameters, and you have left them at the...

osr507mp5
oss674a
oss672a
bnxii_4.6.0
bcme_10.4.3

What version of sco. And where did you get the driver for the nic?

---------- Post updated at 08:20 PM ---------- Previous update was at 08:45 AM ----------

These drivers may work for the on...