Search Results

https://support.hpe.com/hpsc/swd/public/detail?swItemId=MTX_UNITY_I24724


Although, i am unable to connect to it right now, might be down for maintenance. I have attached the file to this post

@RudiC........In this case, SCO is installed by booting from DVD/CD but then reading boot-time disk drivers from a floppy during the process. So it isn't the case that we need the floppy USB stick...

@jgt........They look like two really useful pieces of software. I will be checking them out. Thanks. Like the archaeologist said, "I didn't find it because I wasn't looking for it", however, now...

I thought I had posted this about an hour ago, but...
Copy and run Floppy Boot Disks from USB - gHacks Tech News (https://www.ghacks.net/2006/09/06/copy-and-run-floppy-boot-disks-from-usb/)

Hmmm, well, yes - quite some time ago I managed to make a USB stick look like a bootable 180 kB floppy to my PC, composing floppy boot sector structures (BIOS parameter block, NO MBR!), FREEDOS boot...

This is where a USB floppy drive comes in really handy both to write the BTLD floppies on the Linux box and read them (as BTLD driver(s)) on installation.

Perhaps try to acquire, beg, borrow or...

I used a Linux system to download and extract the EFS package from HP.
The following is an extract from the README
Then you have a new problem: how to create a diskette. I do not know if a BTLD...

Go to the sco site xinuos.com and check the certified hardware list.


According to the hardware list, only the P400 controller is supported, and i am pretty sure that the P410 was never supported.

Hmmmm........sounds a bit tricky. I'm not giving any guarantees but I would start here:

Drivers & Software - HPE Support Center....