Search Results

I started to tell you what I did to disable it on two of my nodes but that was about 4-5 years ago. I figure things have probably changed a bit since then. So I found this link that will give you...

If you are sure there should be entries in the wtmp file and if you or anyone else has logged into that server then there should of course be entries in that file. I would guess that you have a...

I don't fully understand the term "LDAP for AIX" as you mention the LDAP server being Novell eDirectory server. I am guessing you are meaning you are using secldapclntd on the client side and the...

On your VIO Server type oem_setup_envYou should get a # prompt.

This will put into more of a AIX compatible mode where you can run most of the normal AIX commands that zxmaus mentioned.
...

I have not always had 100% success with this and don't know the reasons why but it works way more than not.

If you don't have this set already, type

set -o vi

at the command prompt. I don't...

We had a SAS70 audit at our site a few months back and part of the end result was that I had to install tripwire to monitor our application binaries. We were able to compile tripwire for our AIX 5.3...