8 More Discussions You Might Find Interesting
1. Solaris
Hi,
I'm looking to copy a boot disk on an old Solaris 8 system using dd. I'll bring the system down to single user mode and begin from there. I'm copying my source disk to a larger target disk. Do I need to do anything other than the 'dd' command below because the target disk is bigger? ... (2 Replies)
Discussion started by: sparcman
2 Replies
2. HP-UX
Hi,
I wanted to configure new iscsi port on HPUX system, i added the target port address and configured it, once done, went to array side and searched for that host iqn number , but was nt able to find the same, came to host, then when i ran "iscsiutil -pVS" command it gave me below result
... (0 Replies)
Discussion started by: Vinay Kumar D
0 Replies
3. Solaris
Hi all,
OS is Solaros 10 Sparc
While doing Netbackup upgradation to 7.5 , the server was asked to reboot.
But then it came up in single user mode,
and after I typed format command it showed some disk error.
bash-3.00# format
Searching for disks...WARNING:... (2 Replies)
Discussion started by: manalisharmabe
2 Replies
4. Solaris
Hi, I have a firewire external hard drive that I've been using on a Mac but now want to use on my desktop computer that runs on Solaris 10, but when I plug it into the firewire port, nothing happens. I just assumed that it would mount automatically like a USB device but it doesn't. Can someone... (7 Replies)
Discussion started by: Breanne
7 Replies
5. Shell Programming and Scripting
Hello!
I need to write partitioning script wich would work in rescue mode. It will prepare partitions and unpack linux on it. However I need to calculate whole size of the disk and create:
/dev/sda1 --> One big partition (minus (2*size of memory) for swap)
/dev/sda2 --> Swap partition... (1 Reply)
Discussion started by: pug123
1 Replies
6. Solaris
Hi,
I am a newbie to Solaris. I want to know how to find out the controller target and disk number on a SunFire V890 box that has 6X72GB disks. The probe-scsi output is as shown below:
/pci@8,600000/SUNW,qlc@2
LiD HA LUN --- Port WWN --- ----- Disk description -----
0 0 0 ... (1 Reply)
Discussion started by: sudhir_shet
1 Replies
7. UNIX for Dummies Questions & Answers
Hi there!
I received the following error message
The hard disk at channel 2, target 1 had a soft error.
The output of a system check reveiled the following (see entry <2,1> ):
SWXCR xcr0 error counters:
RAID Array 200 Controller Family Information Utility V1.03... (1 Reply)
Discussion started by: Ivo
1 Replies
8. UNIX for Dummies Questions & Answers
Hello All,
I have a laptop running windows 2000 and I have a External Firewire Hard Disk of 60 GB. Now my question is, " Is it possible to install Solaris 8 on this external Firewire Hard Disk". When I tried installing, It did not find the external Firewire Disk, the only partition information,... (1 Reply)
Discussion started by: sanjay92
1 Replies