9 More Discussions You Might Find Interesting
1. Solaris
Sorry if this is the wrong place for this. I haven't done UNIX Admin in a long time and am trying to update the utilities on a Solaris server so that I can get Apache 2.4.25 installed. I am finding a lot of utilities that are just too far out of date and some versions are no longer supported. So... (0 Replies)
Discussion started by: PJ_Namias
0 Replies
2. HP-UX
Hi,
I wanted to configure new iscsi port on HPUX system, i added the target port address and configured it, once done, went to array side and searched for that host iqn number , but was nt able to find the same, came to host, then when i ran "iscsiutil -pVS" command it gave me below result
... (0 Replies)
Discussion started by: Vinay Kumar D
0 Replies
3. Shell Programming and Scripting
Hi Everyone,
I am trying to connect GDB-7.5.50-1 to the target but I am getting an error
configure: error: invalid value of canonical target .In addition I gave the command ./configure --target=xyz --build= xyz --host=xyz. Furthemore the host and the build system are compeletly running but... (0 Replies)
Discussion started by: Heeka
0 Replies
4. Shell Programming and Scripting
I am trying to debug something using gdbserver, after the successful/YET REALLY SLOW debug session i see that the ash shell on the the target under debug is messed up.
Probably because gdbserver tries to open the core file which is binary. How do i recover from it?
Also any ideas to speed up... (2 Replies)
Discussion started by: dragonpoint
2 Replies
5. Shell Programming and Scripting
I am trying to install Expect 5.43 on my Solaris 10 x86 PC. When I run the make file I get - Command failed for target 'exp_inter.o'. I tried to find the file (find / -name exp_inter.o -print 2>/dev/null) but could not. Where can I get this file from? (2 Replies)
Discussion started by: pazzy
2 Replies
6. Solaris
Hi,
I wish to install solaris 10 on a target machine (t1000) by using Jumpstart. I have configured by jumpstart environment for the same. When i boot the target with the option "boot net -v install" i get the following error...
{0} ok boot net -v install
Boot device: /pci@7c0/pci@0/network@4... (3 Replies)
Discussion started by: hemalsid
3 Replies
7. Solaris
Dear brothers.
i tried so many times to install openssl-0.9.8g in x86 machine. i have done ./config without any error notification. when i execute the make command i am having the same error
fatal error: Command failed for target `build_crypto'.
i installed c compiler the verson of... (1 Reply)
Discussion started by: sayed_021
1 Replies
8. UNIX for Dummies Questions & Answers
Hi everyone
first of all you should know that I've been working with solaris for a few days only. :)
I need to install some programs and I have had the following troubles:
1. When I used /.configure it showed the following message:
"no acceptable C compiler found in $PATH"
I included... (2 Replies)
Discussion started by: eldiego
2 Replies
9. UNIX for Dummies Questions & Answers
Hi there!
I received the following error message
The hard disk at channel 2, target 1 had a soft error.
The output of a system check reveiled the following (see entry <2,1> ):
SWXCR xcr0 error counters:
RAID Array 200 Controller Family Information Utility V1.03... (1 Reply)
Discussion started by: Ivo
1 Replies