netbsd man page for trpt

TRPT(8) 						    BSD System Manager's Manual 						   TRPT(8)

NAME
     trpt -- transliterate protocol trace

SYNOPSIS
     trpt [-a] [-f] [-j] [-p hex-address] [-s] [-t] [-N system] [-M core]

DESCRIPTION
     trpt interrogates the buffer of TCP trace records created when a socket is marked for ``debugging'' (see setsockopt(2)), and prints a read-
     able description of these records.  When no options are supplied, trpt prints all the trace records found in the system grouped according to
     TCP connection protocol control block (PCB).  The following options may be used to alter this behavior.

     -a      In addition to the normal output, print the values of the source and destination addresses for each packet recorded.

     -f      Follow the trace as it occurs, waiting a short time for additional records each time the end of the log is reached.

     -j      Just give a list of the protocol control block addresses for which there are trace records.

     -p      Show only trace records associated with the protocol control block at the given address hex-address.

     -s      In addition to the normal output, print a detailed description of the packet sequencing information.

     -t      in addition to the normal output, print the values for all timers at each point in the trace.

     -M core
	     Extract values associated with the name list from core.

     -N system
	     Extract the name list from system.

     The recommended use of trpt is as follows.  Isolate the problem and enable debugging on the socket(s) involved in the connection.	Find the
     address of the protocol control blocks associated with the sockets using the -A option to netstat(1).  Then run trpt with the -p option, sup-
     plying the associated protocol control block addresses.  The -f option can be used to follow the trace log once the trace is located.  If
     there are many sockets using the debugging option, the -j option may be useful in checking to see if any trace records are present for the
     socket in question.

SYSCTLS
     The following sysctls are used by trpt.  The TCP_DEBUG kernel option must be enabled.

     net.inet.tcp.debug     Structure containing TCP sockets information used by trpt.

     net.inet.tcp.debx	    Number of TCP debug messages.

DIAGNOSTICS
     no namelist
	     When the image doesn't contain the proper symbols to find the trace buffer; others which should be self explanatory.

SEE ALSO
     netstat(1), setsockopt(2)

HISTORY
     The trpt command appeared in 4.2BSD.

BUGS
     Should also print the data for each input or output, but this is not saved in the trace record.

     The output format is inscrutable and should be described here.

BSD
								  August 30, 2007							       BSD