netbsd man page for esh

ESH(4)							   BSD Kernel Interfaces Manual 						    ESH(4)

NAME
     esh -- RoadRunner-based HIPPI interfaces device driver

SYNOPSIS
     esh* at pci? dev ? function ?

DESCRIPTION
     The esh device driver supports the Essential Communications RoadRunner-based HIPPI interfaces.  With some modifications, the driver could be
     made to support the Gigabit Ethernet card based on the same chip.

     The driver supports both a normal network interface and a raw HIPPI Framing Protocol (HIPPI-FP) device.  The HIPPI-FP interface is accessed
     via the /dev/eshN/ulpN set of devices.  There are 255 available Upper Layer Protocols in FP;  these are selectable via the various device
     entries.

     HIPPI is an 800-megabit/sec networking technology which supports extremely large packet sizes.  In order to efficiently use this network, the
     kernel should be configured with extra mbufs, and the default socket buffer size should be increased to at least 192KB, regardless of the
     expected bandwidth-delay product of the network.

     HIPPI ARP is not widely used, and the NetBSD stack does not support it (yet).  In order to define the mappings between IP addresses and
     ifields (the HIPPI MAC addresses), the administrator must make link-layer entries in the routing table using the route(8) command:

	   route add -interface 129.99.154.101 -llinfo -link esh0:3.0.0.65

MEDIA SELECTION
     Media selection is not yet supported for this device.

SEE ALSO
     intro(4), pci(4), eshconfig(8), ifconfig(8), route(8)

BUGS
     The card must be tuned for proper and efficient DMA operation.  The appropriate values vary based on the system.  The eshconfig(8) program is
     used for this.

BSD
								 January 28, 1998							       BSD