debian man page for uhd_cal_rx_iq_balance

uhd_cal_rx_iq_balance(1)					   User Commands					  uhd_cal_rx_iq_balance(1)

NAME
       uhd_cal_rx_iq_balance - Generate RX IQ Balance Calibration Table for a UHD Device

DESCRIPTION
       The  Universal Software Radio Peripheral Hardware Drivers handle calibration information. This application sets up Receiver calibration for
       a daughterboard installed on the USRP. Because it uses the transmit side of the daughterboard as a test signal generator, this  application
       only handles transceiver daughterboards.

   USRP Generate RX IQ Balance Calibration Table Allowed options:
       --help help message

       --verbose
	      enable some verbose

       --args arg
	      device address args [default = ""]

       --tx_wave_ampl arg (=0.69999999999999996)
	      Transmit wave amplitude in counts

       --tx_offset arg (=934400)
	      TX LO offset from the RX LO in Hz

       --freq_start arg
	      Frequency start in Hz (do not specify for default)

       --freq_stop arg
	      Frequency stop in Hz (do not specify for default)

       --freq_step arg (=7300000)
	      Step size for LO sweep in Hz

       --nsamps arg (=10000)
	      Samples per data capture

       This application measures leakage between RX and TX on an XCVR daughterboard to self-calibrate.

SEE ALSO
       uhd_cal_tx_dc_offset(1) uhd_cal_tx_iq_balance(1)

UHD
								    March 2012						  uhd_cal_rx_iq_balance(1)