sys_attrs_emx(5) [osf1 man page]

sys_attrs_emx(5)						File Formats Manual						  sys_attrs_emx(5)

NAME

       sys_attrs_emx - emx subsystem attributes

DESCRIPTION

       The  Emulex  Fibre Channel adapter (emx) kernel subsystem has read-only attributes that provide information about the adaptor driver.  None
       of these attributes can be modified.

       Refer to the sys_attrs(5) reference page for an introduction to the topic of kernel subsystem attributes.

SEE ALSO

       sys_attrs(5)

																  sys_attrs_emx(5)

sys_attrs_bparm(5)						File Formats Manual						sys_attrs_bparm(5)

NAME

       sys_attrs_bparm - bparm subsystem attributes

DESCRIPTION

       This  reference	page  lists and describes attributes for the Boot Parameters (bparm) kernel subsystem. Refer to the sys_attrs(5) reference
       page for an introduction to the topic of kernel subsystem attributes.

	      Identifies the device from which the system was last booted.  This attribute corresponds to the console firmware	environment  vari-
	      able with the same name.	Do not modify this value, which is set when the system boots.

	      A  combination  of  flags  that  controls the boot loader and kernel. This attribute corresponds to the console firmware environment
	      variable with the same name. Values for the variable are: Boot to multiuser mode. By default, the kernel boots to single-user  mode.
	      Enable the kdebug debugger to debug the kernel. By default, kdebug is not enabled in the kernel.	Produce full dumps when the system
	      crashes. By default, partial dumps are produced.	Prompt for an alternate kernel and special arguments when the system is booted. By
	      default, no questions are asked.

	      Set boot_osflags only at the console prompt or by using the consvar utility.

	      Identifies  the  boot device to be used when one is not included in the boot command line. This attribute corresponds to the console
	      firmware environment variable with the same name. Set bootdef_dev only at the console prompt or by using the consvar utility.

SEE ALSO

       Commands: consvar(8)

       Others: sys_attrs(5)

       System Administration

																sys_attrs_bparm(5)