cfnetworkagent(8) [mojave man page]

CFNetworkAgent(8)					    BSD System Manager's Manual 					 CFNetworkAgent(8)

NAME

     CFNetworkAgent -- The network compatibility daemon.

DESCRIPTION

     CFNetworkAgent probes networks for compatibility with system networking mechanisms.

     There are no configuration options to CFNetworkAgent. Users should not run CFNetworkAgent manually.

BSD
								 October 25, 2016							       BSD

ISCONTROL(8)						    BSD System Manager's Manual 					      ISCONTROL(8)

NAME

     iscontrol -- login/negotiator/control for an iSCSI initiator session

SYNOPSIS

     iscontrol [-dv] [-c file [-n nickname]] [-p pidfile] [-t target] [variable=value]

DESCRIPTION

     This command, along with its kernel counterpart iscsi_initiator(4), is obsolete.  Users are advised to use iscsictl(8) instead.

     Internet SCSI (iSCSI) is a network protocol standard, that allows the use of the SCSI protocol over TCP/IP networks, the iscontrol program is
     the userland side of an iSCSI session, see iscsi_initiator(4).  It has 2 modes of operation, if -d (discovery session) is specified, it will
     print out the target names returned by the target and exit.  In the second mode, it will, after a successful login/negotiation, run in daemon
     mode, monitoring the connection, and will try to reconnect in case of a network/target failure.  It will terminate/logout the session when a
     SIGHUP signal is received.  The flags are as follows:

     -c file	     a file containing configuration key-options, see iscsi.conf(5).

     -d 	     do a discovery session and exit.

     -n nickname     if -c file is specified, then search for the block named nickname in that file, see iscsi.conf(5).

     -p pidfile      will write the process ID of the session to the specified pidfile

     -t target	     the target's IP address or name.

     -v 	     verbose mode.

     variable=value  see iscsi.conf(5) for the complete list of variables/options and their possible values.

EXAMPLES

	   iscontrol -dt myiscsitarget

     will start a discovery session with the target and print to stdout the list of available targetnames/targetadresses.  Note: this listing does
     not necessarily mean availability, since depending on the target configuration, a discovery session might not need login/access permission,
     but a full session certainly does.

	   iscontrol -c /etc/iscsi.conf -n myiscsi

     will read options from /etc/iscsi.conf, use the targetaddress found in the block nicknamed myiscsi, login and negotiate whatever options are
     specified, and start an iscsi-session.

SEE ALSO

     da(4), iscsi_initiator(4), sa(4), iscsi.conf(5), camcontrol(8), iscsictl(8)

STANDARDS

     RFC 3720

BUGS

     iscontrol should probably load the iscsi_initiator module if needed.
     Not all functions/specifications have been implemented yet, noticeably missing are the Task Management Functions.	The error recovery, though
     not fully compliant does a brave effort to recover from network disconnects.

BSD
								  October 9, 2014							       BSD