Today (Saturday) We will make some minor tuning adjustments to MySQL.

You may experience 2 up to 10 seconds "glitch time" when we restart MySQL. We expect to make these adjustments around 1AM Eastern Daylight Saving Time (EDT) US.

Linux and UNIX Man Pages

Linux & Unix Commands - Search Man Pages

FreeBSD 11.0 - man page for if_qlxgbe (freebsd section 4)

QLXGBE(4)						   BSD Kernel Interfaces Manual 						 QLXGBE(4)

NAME
qlxgbe -- QLogic 10 Gigabit Ethernet & CNA Adapter Driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file: device qlxgbe To load the driver as a module at boot time, place the following line in loader.conf(5): if_qlxgbe_load="YES"
DESCRIPTION
The qlxgbe driver supports IPv4 checksum offload, TCP and UDP checksum offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling. For further hardware information, see http://www.qlogic.com/.
HARDWARE
The qlxgbe driver supports 10 Gigabit Ethernet & CNA Adapter based on the following chipsets: o QLogic 8300 series
SUPPORT
For support questions please contact your QLogic approved reseller or QLogic Technical Support at http://support.qlogic.com, or by E-mail at <support@qlogic.com>.
SEE ALSO
altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)
HISTORY
The qlxgbe device driver first appeared in FreeBSD 10.0.
AUTHORS
The qlxgbe driver was written by David C Somayajulu at QLogic Corporation.
BSD
April 1, 2013 BSD

Featured Tech Videos