freebsd man page for if_qlxgb

QLXGB(4)						   BSD Kernel Interfaces Manual 						  QLXGB(4)

NAME
     qlxgb -- QLogic 10 Gigabit Ethernet & CNA Adapter Driver

SYNOPSIS
     To compile this driver into the kernel, place the following lines in your kernel configuration file:

	   device qlxgb

     To load the driver as a module at boot time, place the following line in loader.conf(5):

	   if_qlxgb_load="YES"

DESCRIPTION
     The qlxgb driver supports IPv4 checksum offload, TCP and UDP checksum offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and
     IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling.  For further hardware information, see http://www.qlogic.com/.

HARDWARE
     The qlxgb driver supports 10 Gigabit Ethernet & CNA Adapter based on the following chipsets:

     o	 QLogic 3200 series
     o	 QLogic 8200 series

SUPPORT
     For support questions please contact your QLogic approved reseller or QLogic Technical Support at http://support.qlogic.com, or by E-mail at
     <support@qlogic.com>.

SEE ALSO
     altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY
     The qlxgb device driver first appeared in FreeBSD 10.0.

AUTHORS
     The qlxgb driver was written by David C Somayajulu at QLogic Corporation.

BSD
								 November 3, 2011							       BSD