SHOREWALL-TCFILTERS(5) [FIXME: manual] SHOREWALL-TCFILTERS(5)
NAME
tcfilters - Shorewall u32 classifier rules file
SYNOPSIS
/etc/shorewall/tcfilters
DESCRIPTION
Entries in this file cause packets to be classified for traffic shaping.
Beginning with Shorewall 4.4.15, the file may contain entries for both IPv4 and IPv6. By default, all rules apply to IPv4 but that can be
changed by inserting a line as follows:
IPV4
Following entries apply to IPv4.
IPV6
Following entries apply to IPv6
ALL
Following entries apply to both IPv4 and IPv6. Each entry is processed twice; once for IPv4 and once for IPv6.
The columns in the file are as follows (where the column name is followed by a different name in parentheses, the different name is used in
the alternate specification syntax).
CLASS - interface:class
The name or number of an interface defined in shorewall-tcdevices[1](5) followed by a class number defined for that interface in
shorewall-tcclasses[2](5).
SOURCE - {-|address}
Source of the packet. May be a host or network address. DNS names are not allowed.
DEST - {-|address}}
Destination of the packet. May be a host or network address. DNS names are not allowed.
You may exclude certain hosts from the set already defined through use of an exclusion (see shorewall-exclusion[3](5)).
PROTO - {-|protocol-number|protocol-name|all}
Protocol.
DEST PORT (dport) - [-|port-name-or-number]
Optional destination Ports. A Port name (from services(5)) or a port number; if the protocol is icmp, this column is interpreted as the
destination icmp-type(s).
SOURCE PORT (sport) - [-|port-name-or-number]
Optional source port.
TOS (Optional) - [-|tos]
Specifies the value of the TOS field. The tos value can be any of the following:
o tos-minimize-delay
o tos-maximuze-throughput
o tos-maximize-reliability
o tos-minimize-cost
o tos-normal-service
o hex-number
o hex-number/hex-number
The hex-numbers must be exactly two digits (e.g., 0x04)x.
LENGTH - [-|number]
Optional - Must be a power of 2 between 32 and 8192 inclusive. Packets with a total length that is strictly less than the specified
number will match the rule.
EXAMPLE
Example 1:
Place all 'ping' traffic on interface 1 in class 10. Note that ALL cannot be used because IPv4 ICMP and IPv6 ICMP are two different
protocols.
#CLASS SOURCE DEST PROTO DEST
# PORT
IPV4
1:10 0.0.0.0/0 0.0.0.0/0 icmp echo-request
1:10 0.0.0.0/0 0.0.0.0/0 icmp echo-reply
IPV6
1:10 ::/0 ::/0 icmp6 echo-request
1:10 ::/0 ::/0 icmp6 echo-reply
FILES
/etc/shorewall/tcfilters
SEE ALSO
http://shorewall.net/traffic_shaping.htm
http://shorewall.net/MultiISP.html
http://shorewall.net/PacketMarking.html
http://shorewall.net/configuration_file_basics.htm#Pairs
shorewall(8), shorewall-accounting(5), shorewall-actions(5), shorewall-blacklist(5), shorewall-ecn(5), shorewall-exclusion(5),
shorewall-hosts(5), shorewall_interfaces(5), shorewall-ipsets(5), shorewall-maclist(5), shorewall-masq(5), shorewall-nat(5),
shorewall-netmap(5), shorewall-params(5), shorewall-policy(5), shorewall-providers(5), shorewall-proxyarp(5), shorewall-rtrules(5),
shorewall-routestopped(5), shorewall-rules(5), shorewall.conf(5), shorewall-secmarks(5), shorewall-tcclasses(5), shorewall-tcdevices(5),
shorewall-tos(5), shorewall-tunnels(5), shorewall-zones(5)
NOTES
1. shorewall-tcdevices
http://www.shorewall.net/manpages/shorewall-tcdevices.html
2. shorewall-tcclasses
http://www.shorewall.net/manpages/shorewall-tcclasses.html
3. shorewall-exclusion
http://www.shorewall.net/manpages/shorewall-exclusion.html
[FIXME: source] 06/28/2012 SHOREWALL-TCFILTERS(5)